Front Panel
Rear Panel
RS-232
Switches the mode for the RS-232 port.
Normal:
RS-232 HDBaseT pass-through.
Update:
RS-232 firmware update.
Power LED
Solid:
The receiver is powered On
Off
: The receiver is powered Off
Status LED
Flashing:
The receiver is operating normally.
Off:
The receiver is Not operating normally.
HDCP LED
Solid:
HDCP content is present.
Flashing:
HDCP content is not present.
Off:
No signal.
LINK LED
Solid:
Link to receiver has been established.
Flashing:
Link to receiver has not been established.
Copyright © 2016 WyreStorm Technologies |
wyrestorm.com
RX-70-4K v2 Quickstart Guide | 160818
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
2 of 4
Power In
5.5mm Male Barrel Jack/2-pin Phoenix Connector
Connection to this jack is not required when using PoH. See
Power Supply Wiring
for details.
HDBT In
8-pin RJ-45 female
Connect to the
HDBT Out
of a matrix or HDBaseT transmitter. See
HDMI/HDBaseT Wiring
for important wiring guidelines.
HDMI Out
19-pin type A HDMI female:
Supports HDMI and DVI/D (requires adapter-not included).
IR TX/RX
IR TX
- 3.5mm (1/8in) Mono Jack:
Connect to the supplied IR emitter to control a local device from the remote display location via HDBaseT.
IR RX
- 3.5mm (1/8in) Stereo Jack:
Connect to the supplied IR receiver to send IR to the remote display via HDBaseT.
See
IR Wiring
.
RS-232
3-pin Phoenix Connector
Used to send and receive RS-232 signals to/from the source location via HDBaseT and firmware updates.
See
RS-232 Wiring
.
Ethernet
8-pin RJ-45 female | 10/100 Mbps auto-negotiating
Connect to the Ethernet port on a network enabled display.
