For transmission of internet - connect an Ethernet cable
from your internet source to the Ethernet port on the
TRANSMITTER balun.
Connect a good quality, well terminated and tested Cat
5e/6e cable with RJ45 connectors from the UTP OUT
port of the TRANSMITTER to the UTP IN port of the
RECEIVER. Ensure connectors are pushed securely into
each port and supported by the cable strain relief clip
to prevent loosening.
Attention:
UTP cable must be correctly terminated to
568B standard at both ends (see diagram). Inadequate
cable quality or poor RJ45 termination leads to inter-
mittent performance and longer install times.
Connect the HDMI display output (such as: HD-
LCD/HD-DLP) to the HDMI OUT of the RECEIVER.
To view internet on the display - Connect another
Ethernet cable from the Ethernet port on the RECEIVER
to the corresponding HDMI input on your display.
Insert the IR RX 3.5mm jack into the IR RX port on the
RECEIVER. Discretely attach the IR receiver to the
display with the adhesive backing, ensuring a clear line
of sight to the remote control being used. You may
need to adjust the position of the IR RX to achieve best
results.
Extending HDMI using Cat5e to 100 m (328 ft)
with IR source control
Attention:
Do Not Hotplug! - Please insert and extract
cables carefully with the power switched off.
Connecting and disconnecting cables while the unit is
powered can damage circuitry.
Connect the HDMI source input (such as: HD-DVD,
PS3, Cable/Sat box, Blu-ray etc.) to the HDMI IN of the
TRANSMITTER balun. Avoid excessive bending of the
HDMI cable and ensure connectors are inserted firmly
in all ports.
Attention:
We strongly recommend using the supplied
mounting brackets to secure both baluns. Sudden
movement of these devices can lead to unnecessary
service call outs and loss of picture/sound due to stress
on connections.
Position the IR TX emitter sensor over the infrared
receiving area of the source input and fix with the
adhesive backing. You may need to adjust the location
of the emitter later to achieve the best results –
sometimes moving the sensor to different areas on the
source facia can improve IR performance.
Insert the IR TX 3.5mm jack into the IR TX port on the
TRANSMITTER balun.
Tip:
you can locate the small, round infrared sensor by
shining a flashlight onto the facia of devices.
For two-way IR (to control the display from the source
location) insert the IR RX 3.5mm jack into the IR RX
port on the TRANSMITTER balun and connect the
larger, rectangular IR RX receiver to the your chosen
control system. See 9.
1
2
3
4
HDBaseT Extender Set
Part Number
EX-1UTP-IR-100
5
6
7
!
!
RS232
ETHERNET
LINK
DC5V
RS232
ETHERNET
LINK
DC5V
HDMI IN ETHERNET
IR
RX
IR
TX
HDMI IN ETHERNET
IR
RX
IR
TX
TO CONTROL
SYSTEM
POWER
POWER
TRANSMITTER
RECEIVER
REAR PANEL VIEW
REAR PANEL VIEW
ADDITIONAL
CONTROL OF
DISPLAY
THROUGH RS232
LAN
INTERNET
CONNECTION
TO RECEIVER
FROM TRANSMITTER
CONTROL
SYSTEM
1
2
3
4
5
6
7
9
10
11
8
10
10
10
C
A
T
5
e
/6
C
a
b
le
u
p
t
o
1
0
0
m
/3
2
8
f
t
8
