3
6
1
4
7
2
5
8
9
Quickstart Guide
WyreStorm Express™ HD Over Coax (50m/164ft)
EXP-EX-COAX-50
Before Installation
50m/1640ft @1080p video is the maximum recommended
transmission distance for this model and denotes recommended
transmission conditions - including straight cable runs with no
electrical interference, bends, kinks, patch panels or wall outlets.
If any of the above is a factor in your installation, transmission
range may be affected – take care to avoid where possible.
We strongly recommend using supplied mounting brackets to
secure the receiver to a flat surface behind/near the display
device. Sudden movement of these devices could lead to loss of
picture/sound if connections become loose or strained, resulting
in unnecessary service call-backs.
If unsure of positioning, IR sensors can be located on devices by
shining a flashlight onto the fascia of the device - the IR sensor
should be identifiable as a small round sensor behind the panel.
Consult your device manufacturer handbook if difficulties are
experienced.
Setup and Operation
Using quality HDMI cables, connect an HDMI source (such as
Blu-ray, satellite/cable TV) to the HDMI IN of the EXP-EX-COAX-50
transmitter.
Connect a good quality, well-terminated Coaxial cable of no more
than 50m/164ft in length between the COAX OUT of the transmitter
to the COAX IN Input of the receiver.
Connect the HDMI display device (LED/LCD display or projector) to
the HDMI OUT of the EX-EXP-COAX-50 receiver.
Connect the included 5V power supply to both transmitter and
receiver of the EX-EXP-COAX-50 and power on.
Check POWER & STATUS lights are illuminated and static on both
units to indicate successful connection. No or intermittent light
may indicate a connection issue.
NOTE: If daisy-chaining extenders, repeat process for all EX-
EXP-COAX-50 transmitters and receivers used.
IR Control Connection
For two-way IR control of connected sources and displays from
either location, first, connect IR emitters to the IR TX ports of the
EX-EXP-COAX-50 transmitter and receiver.
Firmly attach the IR emitter directly over the infrared receiving
sensors of the devices to be controlled (source at transmitter
location, and display device at receiver location). Location of the
emitter eye on the device may need to be adjusted later to achieve
best IR performance.
Insert IR receiver into IR RX port of the EX-EXP-COAX-50
transmitter and receiver.
At both display and source locations, position the IR receiver on or
near the device to be controlled, ensuring a clear line of sight to the
remote handset used to control it.
Optional: For control system integration a WyreStorm IR
Integration Cable (CAB-IR-LINK) should be used to connect
the IR RX port of the EX-EXP-COAX-50 Transmitter and the
control system.
SOURCE DEVICE
DISPLAY OUTPUT
power
hd
mi
hd
mi
C
o
ax c
a
ble u
p
to 50
m (
164f
t)
ir tx c
a
ble
ir tx c
a
ble
ir rx c
a
ble
ir rx c
a
ble
TRANSMITTER
RECEIVER
Coaxial Cable
Performance Guide
EXP-EX-COAX-50
0ft
328ft
32ft
65ft
98ft 131ft 164ft 197ft 230ft 262ft 295ft
0m
100m
10m
20m 30m
40m 50m
60m 70m
80m 90m
power
3
6
6
1
4
4
7
7
2
5
8
8
9
9
