Front Panel (TX/RX)
Rear Panel (TX/RX)
SET (TX)
3 Position Dipswitch
Used to enable/disable long cable mode
and configure RS-232 port operation. See
Transmitter Set Switch
for operation.
RS-232 Mode (RX)
Used to configure RS-232 port operation. See
Receiver RS-232 Mode
for operation.
EDID
3 Position Dipswitch
Used to set EDIDs to correct resolution
conflicts between the source and the display.
See
EDID Settings
for operation.
Power LED
Solid:
The transmitter is powered On
Off:
The transmitter is powered Off
Status LED
Flashing:
The transmitter is operating
normally.
Off:
The transmitter is Not operating
normally.
HDCP LED
Solid:
Audio and Video signal is HDCP
protected.
Flashing:
Audio and Video signal is not HDCP
protected.
Off:
No Audio and Video signal.
LINK LED
Solid:
Link to receiver has been established.
Flashing:
Link to receiver has not been
established.
Power In
5.5mm Screw Down Barrel Jack
2-pin Phoenix Connecter
Connect to the included 18V DC 1A power
supply to the transmitter. A power supply
is not required on the receiver as it will be
powered using PoH. See
Power Supply Wiring
for important information.
HDBT Out (TX)
HDBT In (RX)
8-pin RJ-45 female | 10/100 Mbps auto-
negotiating
Connect the transmitter HDBT Out to receiver
HDBT In using the cable created in
Pre Wire
step 1.
HDMI In (TX)
HDMI Out (RX)
19-pin type A HDMI female digital video/
audio: Supports HDMI and DVI/D (requires
adapter-not included). Limited to 297MHz
pixel clock
IR TX/RX
3.5mm (1/8in) Mono Plug
IR TX:
Connect to the supplied IR emitter to
control a local device from the remote display
location via HDBaseT.
IR RX:
Connect to the supplied IR receiver to
send IR to the remote display via HDBaseT.
See
IR Wiring
.
RS-232
3-pin Screw Down Phoenix Connector
Used to send and receive RS-232 signals to/
from the source location via HDBaseT and
firmware updates. See
RS-232 Wiring
.
Ethernet
8-pin RJ-45 female | 10/100 Mbps auto-
negotiating
Connect to a Local Area Network or network
device for Ethernet pass-through via
HDBaseT.
Copyright © 2016 WyreStorm Technologies |
wyrestorm.com
EX-70-H2X V1 Quickstart Guide | 161102
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
2 of 4
EX-70-H2X Transmitter (TX)
EX-70-H2X Receiver (RX)
A B C D E F
EX-70-H2X Transmitter (TX)
EX-70-H2X Receiver (RX)
A
B
C
D
E
F
