Wyrestorm EX-70-H2 Скачать руководство пользователя страница 2

Front Panel (TX/RX)

Rear Panel (TX/RX)

Power LED

Solid:

 The receiver is powered On

Off:

 The receiver is powered Off

Status LED

Flashing: 

The receiver is operating normally.

Off:

 The receiver is Not operating normally.

HDCP LED

Solid:

 HDCP content is present.

Flashing:

 HDCP content is not present.

Off:

 No signal.

LINK LED

Solid:

 Link to receiver has been established.

Flashing:

 Link to receiver has not been 

established.

RS-232 Mode

Switches the mode for the RS-232 port.

Normal:

 RS-232 HDBaseT pass-through.

Update:

 RS-232 firmware update.

Power Input

5.5mm Screw Down Barrel Jack 
2-pin Phoenix Connecter
Connect to the included 18V DC 1A power 
supply to the transmitter. A power supply 
is not required on the receiver as it will be 
powered using PoH. See 

Power Supply Wiring

 

for important information.

Status LED

8-pin RJ-45 female | 10/100 Mbps auto-
negotiating
Connect the transmitter 

HDBT Out

 to receiver 

HDBT In

 using the cable created in 

Pre Wire

 

step 1.

HDCP LED

IR TX

 - 3.5mm (1/8in) Mono Jack: Connect 

to the supplied IR emitter to control a local 
device from the remote display location via 
HDBaseT.

IR RX

 - 3.5mm (1/8in) Stereo Jack: Connect 

to the supplied IR receiver to send IR to the 
remote display location via HDBaseT.
See 

IR Wiring

 for more information.

LINK LED

19-pin type A HDMI female
Supports HDMI and DVI/D with adapter

RS-232 Mode

3-pin Phoenix Connector
Used to transmit RS-232 over HDBaseT to 
the remote location and for firmware updates.
See 

RS-232 Wiring

 for more information.

Copyright © 2016 WyreStorm Technologies | 

wyrestorm.com

EX-70-H2 Quickstart Guide | 160803

North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343 

[email protected]

2 of 4

EX-70-H2 Transmitter

EX-70-H2 Receiver

A B C D

E

EX-70-H2 Transmitter

EX-70-H2 Receiver

A

B

C

D

E

Отзывы: