Front Panel (TX/RX)
Rear Panel (TX/RX)
Power LED
Solid:
The receiver is powered On
Off:
The receiver is powered Off
Status LED
Flashing:
The receiver is operating normally.
Off:
The receiver is Not operating normally.
HDCP LED
Solid:
HDCP content is present.
Flashing:
HDCP content is not present.
Off:
No signal.
LINK LED
Solid:
Link to receiver has been established.
Flashing:
Link to receiver has not been
established.
Source Audio Out
Use this connection to send audio separate
from the HDMI connection to the RX.
Audio Return Input
Set the switch to
ARC
to receive audio from
the display via the HDMI connection.
Set the switch to
S/PDIF In
to receive audio
from the display via the S/PDI In connection.
Power In
5.5mm Screw Down Barrel Jack
Connect to the included 18V DC 1A power
supply to the transmitter or receiver. A power
supply is not required on the other end as it
will be powered using PoH..
HDBT In
HDBT Out
8-pin RJ-45 female
Connect the transmitters
HDBT Out
to
receivers
HDBT In.
IR TX
IR RX
IR TX
- 3.5mm (1/8in) Mono Jack: Connect
to the supplied IR emitter to control a local
device from the remote display location via
HDBaseT.
IR RX
- 3.5mm (1/8in) Stereo Jack: Connect
to the supplied IR receiver to send IR to the
remote display location via HDBaseT.
See
for more
information.
RS-232
1x RS-232: 3-pin Phoenix
HDMI In
HDMI Out
19-pin type A HDMI female
Supports HDMI and DVI/D with adapter
S/PDIF In/Out
S/PDIF Out
on the TX transmits audio from
the RX received via HDBaseT.
S/PDIF In
on the RX receives audio to be sent
to the TX via HDBaseT. Audio Return Input
switch must be set to S/PDIF in order for
audio to be transmitted.
Copyright © 2018 WyreStorm Technologies | wyrestorm.com
EX-35-H2-ARC Quickstart Guide | 181012
UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973)
2 of 4
EX-35-H2-ARC Transmitter (TX)
EX-35-H2-ARC Receiver (RX)
A B C D
E
F
EX-35-H2-ARC Transmitter (TX)
EX-35-H2-ARC Receiver (RX)
A
B
C
D
E
F
Troubleshooting
No or Poor Quality Picture (snow or noisy image)
• Verify that power is being supplied to the transmitter and receiving device.
• Verify that all HDMI and HDBaseT connections are not loose and are
functioning properly.
• Verify that the HDBaseT cable is properly terminated following EIA568B
standard.
• Verify that the output resolution of the source and display is supported by
this extender.
• Configure EDID Settings to a lower resolution.
• If transmitting 3D or 4K, verify that the HDMI cables used are 3D or 4K rated.
No or Intermittent 3rd party Device Control
• Verify that the IR and RS-232 cables are properly terminated following the
section.
Troubleshooting Tips:
• WyreStorm recommends using a cable tester or connecting the cable to
other devices to verify functionality.
