WWBeds Face Unassembled Alpha Murphy, Руководство по сборке

Страница: 8 / 18

BACK TO REGULAR INSTRUCTIONS
Video:
​ Cabinet part 2
Stand the unit up and into its approximate place in the room. Check that the cutout made to clear your
base molding is sufficient. If not make the height it needs to be. Lay the unit back down on the face,
and adjust the cutout.
Bottom Rear Base and Bottom Kick
Bottom Rear Base and Bottom Kick will be the same width (4”) Some drawings may show them different sizes.
If you have added base molding is base molding may be attached to the Front Bottom Kick as in this example
3-9 Prep the Bottom Rear Base and Bottom Kick by adding 2 brackets on each end.
(NOTE: Some models this step may be done for you or you may see where the brackets were once put
on
​ )
Lay both Bottom Rear Base and Bottom Kick face down on a clean soft surface. Flush the two brackets on
each end (about ½”-¾” from the top and bottom edge). Secure with ¾” screws.
(NOTE: Face will be the best side. If you can not tell which side is the best then it will not matter.)
3-10. Attach the Bottom Rear Base. Both the Bottom Rear Base and Bottom Kick will be the same height. You
may want to use the better one for the front Bottom Kick. With the brackets facing toward the front, bring the
Bottom Rear Base into so that it clears any cutouts that were made for the base molding
3-11. Attach the Bottom Kick by setting it back 1” from
the front of the Side Panels. These brackets will face
the wall/inside. Secure with ¾” screws.
Special application: If you have added base
molding, the Bottom Kick may be attached to that
base molding and may not have the 1” set back. Also in some cases the Bottom Kick will be replaced
by added base molding.
NOTE: The small control box will be just sitting there and will be attached to the frame later.