wurth SWS 180/230 Power, Руководство по эксплуатации

Страница: 3 / 6

8
Tool Specifications
Angle Grinder SWS 180 Power SWS 230 Power
Article number 702 496 X 702 498 X
Input power 2 500 W 2 500 W
Output power 1 700 W 1 700 W
No-load speed
8 500 RPM 6 600 RPM
Grinding disc dia. max. 180 mm max. 230 mm
Grinding disc thickness min. 1 mm, max. 10 mm min. 1 mm, max. 8 mm
Mounting hole 22.2 mm 22.2 mm
Weight approx. 5.4 kg approx. 5.4 kg
Safety class
/
II
/
II
Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions con-
tained therein are strictly followed.
In addition, the general safety in-
structions in the enclosed booklet
must be followed.
If the cable is damaged or cut through
while working, do not touch the cable
but immediately pull the mains plug.
Never use the machine with a dam-
aged cable.
Wear protective goggles, ear protec-
tors and face mask.
Wear protective gloves and sturdy
shoes. When necessary, also wear an
apron.
When working with the machine, al-
ways hold it firmly with both hands
and provide for a secure stance.
❑ For all work with the machine, the auxiliary han-
dle
6 and the protective guard 7 must be mounted.
❑ Use only grinding tools whose allowable speed is
at least as high as the no-load speed of the ma-
chine.
❑
Observe the dimensions for the grinding disc. The
mounting hole diameter must fit the centring flange
(square form part). Do not use reducer pieces or
adapters.
❑ Check grinding tools before use. The grinding tool
must be properly mounted and turn freely. Perform
a test run for at least 30 seconds without load. Do
not use damaged, out of round or vibrating grind-
ing tools.
❑
Do not clamp the machine in a vice.
❑
Always direct the cable to the rear away from the
machine.
❑
Clamp the workpiece in case it does not remain
stationary from its own weight.
❑
When grinding metal, flying sparks are produced.
Take care that no persons are endangered. Be-
cause of the danger of fire, no combustible mate-
rials should be located in the vicinity (spark flight
zone).
❑
Apply the machine to the workpiece only when
switched on.
❑
Always switch off the machine and allow to come
to a stop before putting down.
❑ Keep hands away from rotating grinding tools.
❑ Connect machines that are used in the open via a
residual current circuit breaker with a triggering
current of 30 mA maximum. Use only extension
cables that are intended for outdoor use and are
protected against splash water.
❑
For the labelling of the machine, do not drill into
the housing or attach with rivets. The protective in-
sulation is then no longer ensured. Use stickers.
❑ Use only original WÜRTH parts and accessories.
For your safety
GB
☞
For further notes on safety refer to enclosed Sheet