wurth DIGA CSM-1, Руководство по эксплуатации

Страница: 16 / 173

16
Troubleshooting and Eliminating Malfunctions
Malfunction Possible Cause Corrective Action
Green indicator on char-
ger remains dark; bat-
tery can not be charged Plug of the power supply not completely plugged
into the mains outlet or connection to the charge
cradle disconnected
Mains outlet defective
Green LED indicator or charger/power supply
defective
Plug in the power supply plug properly; plug the
charge connector properly into the charge cradle
Have mains outlet check by a qualified electrician
Have charger/power supply checked by an
authorized Würth customer service agent
Blower motor does not
start after pressing
against the neck-down
sleeve; charge-control
indicator dark Battery not inserted properly
Battery contacts contaminated, oily or corroded
Battery is deep discharged or defective
Blower motor defective
Take out battery and insert again until it engages
Clean the battery contacts
Charge or replace battery (see Section “Battery
and Charger”)
Have tool checked by an authorized Würth custo-
mer service agent
Firing procedure is not
actuated after pressing
down the neck-down
sleeve and pulling the
trigger; blower motor
runs normal;
charge-control indicator
dark Gas cartridge empty; check contents of the gas
cartridge
Metering valve defective, combustion space is not
filled with gas
Ignition device/spark plug defective
Remove gas cartridge and press metering valve
approx. 2 - 3 times against a firm object. Each
time a small quantity of gas should escape, other-
wise replace gas cartridge
Replace metering valve
Have tool checked by an authorized Würth custo-
mer service agent
Neck-down sleeve can
not be pushed in all the
way or only partially Blockage due to magazine jam; fastening
bolt/nail jammed in discharge channel
Neck-down sleeve and driver blade move sluggish
due to contamination
Driver blade not seated correctly behind the faste-
ning bolt
Contact arm of the neck-down sleeve warped or
defective
Clear magazine jam (see section “Clearing a
Jam”)
Clean the discharge channel and the neck-down
sleeve with compressed air. Open the locking fix-
ture (observe instructions!)
Clean neck-down sleeve with compressed air and
slide the driver blade upward
Have tool checked by an authorized Würth custo-
mer service agent
Magazine strip is not
transported further Usage of incorrect magazine strips
Magazine strip/tensioning slider move sluggish
Use only original Würth fastening bolts/nails
Clean magazine
Shooting capacity decre-
ases heavily or is insuffi-
cient; fastening
bolts/nails are not dri-
ven in completely Insufficient filled combustion space or gas cart-
ridge almost empty
Overheating due to insufficient cooling or
air-intake
Compression loss in the combustion space
Test: Press neck-down sleeve against surface for
approx. 1 minute and then actuate trigger. When
no shooting procedure is actuated, compression
loss is given
Check adapter piece and gas cartridge for correct
seating or replace gas cartridge
Do not hold hand in front of lid; clean filter mat
Have tool checked by an authorized Würth custo-
mer service agent
Neck-down sleeve does
not return back to star-
ting position after a shot Driver blade worn or warped; piston seized due to
defective piston rings; contact arm of the
neck-down sleeve warped
Exhaust openings contaminated or clogged
Have tool checked by an authorized Würth custo-
mer service agent
Clean exhaust openings
Tool works irregularly;
blower motor intermits Internal electric cable interruption or loose connec-
tion Have tool checked by an authorized Würth custo-
mer service agent
DIGA CSM-1.book Seite 16 Freitag, 15. August 2008 1:20 13