Würth 0978 950 006, Быстрое руководство по установке

Страница: 5 / 12

CONFIGURATION
The module can be configured for manual/automatic operation by lifting the front glass of the module
(see figure below).
AUTOMATIC : In this mode, control takes place exclusively via an advanced home automation system and not
via a smart wifi programmable thermostat; in this mode the module must be addressed by means of the PI button,
accessible on the front side of the module by lifting the front glass; as regards the addressing procedure, refer to
the installer manual of the home automation programming software.
MANUAL : Mode to select when you want to manage the module via smart wifi programmable thermostat.
In this mode the module contains the function to manage the outputs in dimmer mode, with the following
pre-programmed actions:
OUT1 controlled from impulse IN1.
OUT2 controlled from impulse IN2.
OUT3 controlled from impulse IN3.
OUT4 controlled from impulse IN4.
ON all BUS scenario from impulse IN5.
OFF all BUS scenario from impulse IN6.
The scenario controls can alternatively be activated directly from the Wüdomo App. In this mode the
module can work autonomously, requiring only the connection of the power supply voltage; if you wish to
connect several modules, in order to use the scenario functions, simply interconnect the various modules with the
BUS cable, and therefore with the signals 12V, GND, A and B.