Würth 0772 122 42, Перевод оригинальной инструкции по эксплуатации

Страница: 12 / 124

12
Notes on troubleshooting
Malfunction Cause
Reverse connection LED [11] is not lit.
– Booster cable clamps are not connected.
– Vehicle battery voltage is less than 4 V or vehicle bat -
tery is missing altogether.
– Short circuit in a vehicle battery cell
Reverse connection LED [11] lights red. – Booster cable clamps are connected incorrectly.
LEDs [2] and [10] light red. – Charge of booster kit too low; charging not pos-
sible.
LED [4] or [7] lights red. – No voltage on booster cable clamps; start-up
procedure not possible.
– Charge level of booster kit battery too low.
– Fuse integrated into the device defective.
Device switches off after start-up attempt. – Vehicle causes a short circuit; remove defective
vehicle battery
Cleaning and maintenance
Important!
The device may only be cleaned with
the mains plug disconnected.
Environmental protection
Do not dispose of the device with
domestic waste. Have the device
disposed of by an authorised waste
management company or your
municipal waste management
organisation. Adhere to the applica-
ble regulations. In case of doubt
contact your waste management organisation.
Recycle all packaging material in an environmen-
tally friendly manner.
Batteries:
Do not dispose of batteries with domestic waste,
do not expose to fire or water. Collect and recy -
cle batteries or dispose of with due care for the
environment.
Warranty
For this Würth appliance the following guarantees
apply:
– Battery booster kit and charger: 24 months
– Battery in battery booster kit: 12 months
– Cable clamps and fuses are excluded as they are
wear parts.
The warranty period starts with the date of purchase
(verified by invoice or delivery document).
Faults covered by warranty shall be eliminated by
replacement or repair. Damage caused by improper
operation is not covered by warranty.
Claims under warranty shall only be considered if
the device is returned fully assembled to a Würth
agency, your Würth sales representative or a
customer service workshop for electrical equipment
authorised by Würth. Technical changes reserved.
We accept no liability for printing errors.
Accessories and spare parts
In the unlikely event of a failure or defect, have the
device repaired by a Würth masterService work-
shop. In all your queries and spare part orders,
always quote the product number (see type plate) of
your device.