Instrument configuration (CONFIG mode)
Turb 2000 Series
30
ba75695e03 10/2013
Change the brightness by pressing the
or
button. Once the desired brightness has been set,
press the
OK
button to accept it.
6.12
Setting the units
The most common unit is NTU (Nephelometric Turbidity Units) however the instrument can display in
FNU (Formazin Nephelometric Units). All instruments are shipped from the factory set in NTU mode.
Make a selection using the
and
buttons then press the
OK
button.
6.13
Ultrasonic cleaning (Turb 2020 and 2120)
This allows for a selection menu to turn off the ultrasonic cleaning function if desired. The default mode
is On. Make a selection using the
and
buttons then press the
OK
button.
6.14 RS-485
Parameters
The following menus can be used to modify the RS-485 parameters. These menus will only appear if
the RS-485 is enabled (see 6.1). The default is 8 Bit, no (nOnE) Parity, 1 Stop Bit. Make selections
using the
and
buttons then press the
OK
button to move to the next menu.
