wtw OxiTop Control OC 110, Руководство по эксплуатации

Страница: 19 / 102

OxiTop
®
Control OC 110 Operation
ba31116e05 07/2014
19
4.3 Navigation
4.3.1 Operating modes
BOD Routine :

Measurement of single samples for a BOD
x
(x = 0.5h ... 99d) at 20 °C

The measuring range and filling volume can be selected out of seven per-
manent ranges and the corresponding filling volumes.

The function is permanently switched on
BOD Standard :
(preselected)

Measurement of up to 12 parallel sample processes per overall sample for
a BOD
x
(x = 0.5h ... 99d) at 20 °C

The measuring range and filling volume can be selected out of seven per-
manent ranges and the corresponding filling volumes.

Automatic sample statistics with averaging

The AutoTemp function and the GLP mode can be switched on
BOD Special :

Measurement of up to 12 parallel sample processes per overall sample for
a BOD
x
(x = 0.5h ... 99d)

Measuring range, dilution, bottle volume and sample volume can be set

The altitude above sea level and the starting air pressure respectively can
be set

The incubation temperature (5 °C to 40 °C) can be set up

Automatic sample statistics with averaging

The AutoTemp function and the GLP mode can be switched on
Pressure p :

The Pressure p mode is a pure pressure measurement

The absolute pressure of single samples is measured between 500 hPa and
1350 hPa

A "limit pressure“ can be set

Up to 10 manually triggered measurements (momentary values) are saved
with pressure value and point in time

The GLP mode can be switched on