Trinkwassertafel
Maintenance and cleaning
37
ba75752e01
08/2008
4
Maintenance and cleaning
4.1
Maintenance
Maintenance activities
4.2
Cleaning
Panel and components
Clean the wall mounting panel, tubes and component surfaces by
wiping them with a moist cloth.
Tubes, inside cleaning
Basically, it is not necessary to clean the insides of the tubes. If
required, the pipe system can be cleaned as follows:
Note
For cleaning, remove the sensors from the flow-through vessel and,
where necessary, clean them according to the instructions in the
respective sensor operating manual.
Component
Maintenance
Pipe system
Regularly check all joints for
traces of escaping water (visual
control)
Monitor
(see monitor operating manual)
Sensors
Depending on the sensor type
(see sensor operating manual)
Other components
See component operating manual
Contamination
Cleaning agents
Implementation
Lime and hydroxide
coatings
Acetic acid (10 %)
– Close the inlet
and outlet
– Pour cleaning
agent into the
flow-through
vessel from above
and leave to take
effect
– Subsequently
rinse thoroughly
with water.
