wtw DIQ/S 182-MOD, Руководство по эксплуатации системы

Страница: 47 / 150

System 182 Installation
3 - 33 ba75504e07 04/2012
3.8.2 DIQ/S 182-MOD/24V (24 V version)
Warning
If the 24 V AC/DC supply is incorrectly connected, it may
represent a danger to life from electric shock. Pay attention to the
following points during installation:

The Universal Transmitter DIQ/S 182-MOD/24V may be
connected by a skilled electrician only.

The 24 V AC/DC supply must meet the specifications quoted on
the name plate and in chapter 10 T
ECHNICAL DATA
(protective
low voltage SELV).

The Universal Transmitter DIQ/S 182-MOD/24V may be
connected in a voltage free condition only.

When installed in a building, a switch or power switch must be
provided as an interrupt facility for the System 182.
The interrupt facility must
– be installed in the vicinity of the DIQ/S 182-MOD/24V
Universal Transmitter and must be easily accessible to the
user, and must
– be labeled as the interrupt facility for the
DIQ/S 182-MOD/24V Universal Transmitter.
Note
Rechargeable battery systems should have a deep discharge
protection. The DIQ/S 182-MOD/24V does not have any built-in deep
discharge protection.
Materials required

Wire end sleeves, suitable for the 24 V AC/DC feed line, with
suitable crimping tool

1 x screwed cable gland with sealing ring (scope of delivery of the
Universal Transmitter).
Tools

Cable stripping knife

Wire stripper

Phillips screwdriver

Small screwdriver.
Preparing the 24 V AC/
DC line
1 Cut off the cable to the required length.
2 Strip the cable insulation for approx. 45 mm.
3 Bare the wires 1 and 2 and fit them with wire end sleeves.