WTI SW720HV-H.264-TI, Руководство по эксплуатации

Страница: 18 / 21

AC LINE CONNECTIONS
The AC Line connections should be connected to an AC mains source with a voltage of
85VAC to 265V AC, operating at a frequency of 47Hz to 63Hz. The nominal operating
voltage is normally 115VAC or 230VAC. The camera draws 50 Watts maximum, which
translates to about 0.6 Amps at the worst case low line voltage of 85VAC.
The “hot” side of the AC mains connections should applied to Pin U of the 18 pin MS
connector.
The “low” side of the AC mains connections should applied to Pin T of the 18 Pin MS
connector.
The AC mains safety ground connection should applied to Pin G of the 18 Pin MS
connector.
ETHERNET DATA AND VIDEO CONNECTIONS
The PTZ camera control functions and video streaming functions to and from the
SW720HV-H264-TI camera are transmitted over a 100Base-TX Ethernet connection
using specific Ethernet ports assigned for each of the various functions and protocols.
CAMERA PTZ CONTROL PROTOCOLS AND PORTS
The SW720HV-H264-TI camera supports COHU, Pelco D, WTI, NTCIP and
Web/ONVIF protocols over Ethernet and through the optional RS-485 data
connections.
The various protocols are accessed through the use of different port numbers
when sending camera control commands to the Sidewinder using an Ethernet
connection.
COHU
Protocol: 55002
Pelco D Protocol: 55001
WTI Protocol: 53935
NTCIP Protocol: 55000
Web/ONVIF Protocol: 55003
OPTIONAL HARD WIRED PTZ CONTROL PORT
An optional hard wired RS-485 port can be configured on the SW720HV-H264-
TI camera for special situations. These signals are provided on pins M, N, R and S
of the 18 pin MS connector and can be wired to the normally unused Blue and
Brown twisted pairs on the CAT-5e extension cable (see wiring chart). This
option MUST be ordered at time of purchase.
SW720HV-H.264-TI WTI ~ Page 18 of 21