WTC MedWeld 3005, Руководство оператора

Страница: 21 / 206

=UTGU\T# %?fUbfYUg
=UTGU\T# %?`UbQd_bµc7eYTUD)## " !%
= #" "%1`bY\" "
On the processor module are several LEDs (light-emitting
diodes). They indicate the status of the processor. These are the
status indications:
3QedY_^*
6_bSUT9?YcQ`b_WbQ]]Y^WTUReWWY^Wd__\
4ebY^W^_b]Q\_`UbQdY_^dXUS_^db_\cX_e\T>?D
RUVe^SdY_^Y^WgYdXV_bSUT9?
:7&:HOG3URFHVVRU
The weld processor provides a firing signal to the firing card, as
required by the weld schedule. The firing card then provides the
single-phase gate signals to the SCRs, which then send welding
voltage to the weld transformer to apply weld current to the
work piece.
The weld processor module provides three connectors for system
communications; the Programming port, the MedLAN port and
the WTC firing card interface port.
Programming port (top): Use this connector to plug a
programming device directly into the WTC weld processor card.
• Connect a DEP-100S Data Entry Panel to the Programming
port to program the control’s basic operating parameters and
set its network address.
PC RUN
On steadily: The SLC processor is in Run mode.
CPU FAULT Flashing at power up: The processor has not been
configured.
Flashing during operation: The processor detected
a major error either in the SLC processor,
another card in the rack or in memory.
On steadily: This indicates any loss of
communications.
FORCED I/O
Flashing during operation: One or more input or
output addresses have been forced to an ON or
OFF state, but the forced ON or OFF is not
enabled.
On steadily: Indicates the forced ON or OFF state
is enabled.
BATTERY
LOW
On (steadily): Indicates the battery voltage has
fallen below a threshold level, or the battery and
the jumper are missing.