WTC MedWeld 3005, Руководство оператора

Страница: 107 / 206

GU\TCSXUTe\Uc
=UTGU\T# %?`UbQd_bµc7eYTUD)## " $"#
= #" "%1`bY\" "
([WHQG5HSHDW
)XQFWLRQVSJ
67 EXTEND WHILE INPUT #n IS #m (0 = OFF 1 = ON)
(n = 1-8 m = 0-1)
75 EXTEND UNTIL NO INITIATE
62 REPEAT (AT NEXT FUNCTION)
6WHSSHU$VVLJQPHQW
)XQFWLRQV
SJ
82 LINEAR STEPPER #nn ASSIGNED (0 = OFF)
83 SUREWELD STEPPER #nn ASSIGNED (0 = OFF
86 TIP DRESS ADVANCE GROUP #nn STEP #m
(nn = 1-99 m = 1-5)
)XQFWLRQVWKDW
2YHUULGH6HWXS
3DUDPHWHUV
SJ
19 KVAT LIMIT: HI=nnnn0 LOW=nnnn0
76 SEC. CURR LIMITS: HI=nnnn0 LOW=nnnn0
77 ISOLATION CONTACTOR DELAY=nn SEC
84 WINDOW: HI=+ nn% LO= -nn% C-FACTOR=nnn
90 TRANSFORMER TURNS RATIO NNN:1 (NNN=1-256)
96 POWER FACTOR LIMIT: HI=nn% LOW=nn%
97 C-FACTOR LIMIT: HI=nnn LO=nnn
7HVW)XQFWLRQV
SJ
39 TEST FIRE nn% CURRENT (mm = 20-99)
80 VERIFY TIPS DOWN EVERY 00 CY mm TIMES
81 SLOW CYLINDER TEST EVERY 00 CY mm TIMES
91 FAULT IF TIPS TOUCHING
92 FAULT IF TIPS NOT TOUCHING
93 INITIAL PF LIMIT: HI= nn% LOW = nn%
98 GOTO SEQ#mm IF CURRENT LESS THAN nnnn0
(mm = 1-99)
6SHFLDO)XQFWLRQV
SJ
94 EXTEND WELD IF LOW CURRENT LIMIT FAULT
95 EXTEND WELD IF CURRENT LESS THAN nnnn0 AMPS
99 GOTO SEQ #nn
78 PROCESS WELD FAULTS
89 VERIFY CYLINDER #N IS OUT OF RETRACT (n = 1-2)
78 PROCESS WELD FAULTS
80 VERIFY CYLINDER #0 IS OUT OF RETRACT
61 ABORT IF NO INITIATE FOR nn CYCLES
63&,QGH[)XQFWLRQV
SJ
87 SET SPC OFFSET TO nn
88 SEND ALL SAMPLES UNTIL NEXT SPC OFFSET
$QDORJ3UHVVXUH
&RQWURO)XQFWLRQV
SJ
08 SET VALVE n CYLINDER RESSURE TO mm PSI
09 WAIT nn CYCLES FOR PRESSURE ACHIEVED
13 SET VALVE n TOUCH DOWN RESSURE TO mm PSI
14 SET VALVE n TIP DRESS RESSURE (PSI)