Wright Manufacturing Stander ZK Series, Инструкция по эксплуатации

Страница: 22 / 44

22
WARNING
operation of the hand controls and the mo
wer’s behavior. After gaining a good feel for how the mower
handles, gradually attempt higher engine speeds until familiar with operation at full throttle engine speed.
Unusual noises or irregular operation:
As you drive the mower, listen for any unusual noises and test for irregular operation and adjust or service
as necessary.
5.4 How to Stop and Park the Mower
Come to a complete stop. If the blades are on, turn them off using the switch on the instrument panel.
Make sure the control levers are in the exact neutral position. Set the parking brake, reduce the engine
speed to idle, shut off the ignition switch to stop the engine and then remove the key from the ignition
switch. The mower is now parked. Do not leave mower unattended on a sloped surface.
5.5 Driving the Mower Over a Curb
To climb a curb, first see the Safety Instruction Manual section of this manual, especially the parts on:
•Initial Operating Safety Guidelines
•Operation In Reverse
•Operation In Forward Direction
It is recommended to use ramps for curbs 5” and higher. Using ramps, you can easily back on and off
without damaging your mower or the curb.
Curbs 5” and lower, raise the mower deck into the highest position. Then drive the mower in reverse at a
45 degree angle to the curb (with the left side of the mower closest to the curb) until you are within an inch
or two of the left-rear tire hitting the curb. Stop and then gradually bump into the curb with that tire until it
is just on top of the curb. If the tire slips even while lurching the mower into the curb, then the curb is too
high and you should use ramps or find another way. The mower should still be at a 45 degree angle to
the curb. Now, while maintaining the same angle to the curb, continue to back up until the right-rear tire is
close to the curb. Using the same technique lurch the right tire onto the curb. After both wheels are on
top of the curb, turn the mower counterclockwise and back up so the left caster wheel comes over and last
should be the right caster wheel as the mower is twisting to the left (counterclockwise). The technique
works the best if you try not to drive backwards at a near 90 degree angle to the curb but get all of the
wheels to go over while the mower is moving at least a 45 degree angle to the curb. To drive off a curb,
first try driving up onto it to make sure the curb is not too high. If the curb is not too high, drive the right-
front caster off first while driving toward the curb at a 45 degree angle (the curb should be to your right).
Then, maintain that 45 degree angle so the left caster goes over, then the right-rear wheel, then the left
rear wheel. Do NOT step off the mower during ANY maneuver.
Brake ON
Brake OFF