4K Wallplate HDBaseT Transmitter
7
Installation
①
If installing in a back-box, it is recommended that the transmitter be installed in a
4-5/8” square box as a minimum. The 4-5/8” square box has sufficient space to
terminate the cables with jacks behind the unit when fully installed.
②
Run one twisted pair cable from the transmitter location to the site where the
HDBaseT Receiver will be located (somewhere near the display device).See the
installation instructions for the 70M HDBaseT Receiver.
③
If using the Control Panel, please run another twisted pair cable from the
transmitter location to the location that the Control Panel will be mounted.
④
All twisted pair cables should be terminated with jacks. This allows the permanent
link between the two devices to be tested.
⑤
Use the appropriate category rated patch cable to connect the HDBaseT link to
the HDBT OUT connector.
⑥
If using the Control Panel, use the supplied adapter cable to connect with the
second cable and follow the installation instructions for the HDBaseT Receiver
and Control Panel.
Note:
Category 6A cabling with alien crosstalk prevention technology is recommended
to be used for ensuring the performance of HDBaseT link.
