HDBaseT 1x4 Splitter Kit ( PoH )
6
3.2 HDBaseT Splitter Rear Panel
No. Name
Description
①
HDMI IN
HDMI port for connecting the HDMI source device (Blu-ray
Disc™ or DVD player, gaming console, etc.).
②
OUTPUTS
l
HDMI: HDMI loop output port for connecting a local
display.
l
HDBT1~4: Four HDBaseT RJ45 jacks with PoH support
for connecting the four HDBaseT receivers.
l
IR IN: Four 3.5mm IR input jacks for connecting the four
IR receivers.
③
IR Control
l
IR ALL IN/LOOP IN: 3.5mm IR IN jack for connecting an
IR receiver or cascading to previous device.
l
IR OUT: 3.5mm IR OUT jack for connecting an IR emitter.
l
IR LOOP OUT: A 3.5mm IR LOOP output jack for
cascading to next device.
④
RS232
Control
l
RS232 IN: 3-pin RS232 connector. Connect to the PC by a
3-pin to DB9 cable.
l
RS232 OUT: If cascading multiple units, use the 3-pin to 3-
pin cable to connect the output to the RS232 IN on the
next device in the chain.
⑤
ID PRESET
Assigns a single digit ID to the splitter when cascading
multiple splitters and using RS232 control, each splitter must
have a unique ID. Use a small, flathead screwdriver to set the
ID. There are sixteen positions, with
0
at the fully
counterclockwise position and
F
at the fully clockwise
position. After setting the ID, the device must be restarted for
the new ID to take effect.
ID PRESET
DC 24V
OUTPUTS
RS232 OUT
Tx
Rx
RS232 IN
Tx
Rx
HDMI
INPUT
HDMI
IR OUT
CONTROL
IR IN
IR IN
IR IN
IR IN
HDBT 1
HDBT 2
HDBT 3
HDBT 4
1
2
3
4
5
6
