2020V1.6
Transmitter Panel Description
1.
CATx OUT:
RJ45 port to connect the CATx IN port of receiver by CATx cable. It
supports 12V PoC to power the receiver. The orange LED illuminates when there is a
valid HDMI signal input. The green LED illuminates when power is applied.
2.
IR IN:
3.5mm mini jack to connect IR receiver for IR pass-through.
3.
IR OUT:
3.5mm mini jack to connect IR emitter for IR pass-through.
4.
DISPLAY:
Type-A female HDMI port to connect HDMI display device.
5.
SOURCE:
Type-A female HDMI port to connect HDMI source device.
6.
DC 12V:
DC connector for the power adapter connection.
7.
EDID Management:
§
EDID BYPASS: Press the button with paper clip or other sharp tool to learn the
EDID from the remote display connected to the Receiver’s HDMI out.
§
EDID COPY Tx/3s: Press and hold the button for 3 seconds to copy the EDID from
the local display connected to the Transmitter’s HDMI out.
§
DEFAULT: Factory default, the source device learns EDID from the TV which has
the lowest resolution. Press and hold the button while the product is in turned-off
period, and then release the button after 6 seconds of power on can restore the
default setting.
Note:
If the standard resolution of the local display is lower than the receiver‘s, the unit
will output the video with the lower resolution to ensure video can be shown on both
displays.
EDID BYPASS
EDID COPY Tx/3s
IR OUT
IR IN
CATx OUT
DISPLAY
SOURCE
DC 12V
1
2
3
4
5
6
7
