Woxcon CE-EX50, Руководство пользователя

Страница: 10 / 12

CE-EX50
10
7. Connect and Operate
1. Connect a source such as a Blu-Ray Player, game console, A/V Receiver, Cable or
Satellite Receiver, etc. to the HDMI input on the Transmitting unit.
2. Connect a display such as an HDTV or HD Projector to the HDMI output on the
Receiving unit.
3. Connect a single Category 5e/6 up to 164ft/50m to the output of the Transmitting
unit, and the other end to the input of the Receiving unit.
4. For power, plug both the Transmitting unit and Receiving unit with the included
power supplies.
5. Power on each device in the same sequence (receiver and transmitter will already
be powered when either unit is plugged in.)
At this point the display connected should display the source signal connected to the
extender set. If no signal is being displayed, check the receiver EQ swithcer. If a
display is having difficulty receiving a signal, see EDID section and perform EDID
learning or access the display’s menu and adjust the resolution (lowest to highest
until signal is displayed). A 24 Hz vertical refresh rate may work better than 60 Hz or
higher. Use the source remote at the receiver emitter to test IR functionality. If the
IR remote function is not responding, check the emitters to ensure they are placed
correctly and are plugged into the correct IR jacks on the Extender set receiving and
transmitting units.