Worx WX820L, Руководство пользователя

Страница: 13 / 32

OPERATING INSTRUCTIONS
Using the Variable Speed Dial
(Speed settings 1-6)
NOTE: Before using the tool, read the
-The Variable Speed Dial can be used to
set the optimum speed according to the
instruction book carefully.
sanding plate used and the respective
INTENDED USE:
application.
This machine is intended for dry sanding of wood,
plastic, filler and coated surfaces. The sander is not
to be used for plaster or spackle.
ASSEMBLY AND OPERATION
ACTION
ASSEMBLY
Fitting & Replacing the Sanding
Plate
Note: Read and understand the
instructions before assembling or
changing sanding plates.
Note: Open the Hyperlock lever
completely when attaching or removing
a sanding plate.
Note: When assembling the finishing
plate/detail plate, first check the
assembling direction.
WARNING! The sanding
plate must be attached
before starting the sander.
WARNING! Avoid pinching
hands and fingers when
using the Hyperlock TM .
WARNING! Do not touch the
bottom fan after use to
avoid high-temperature burns.
Fitting the Sanding Paper
Attaching the Dust Bag
Caution:
To prevent the possibility of dust or a
foreign body being thrown into your face
or eyes, never attempt to use your sander
without the dust bag properly installed.
Charging the Battery Pack
Installing the Battery Pack
OPERATION
Switching On/Off
Application
Sanding
down
varnishes
FIGURE
Sanding
paint
Touching up
paintwork
Sanding
wood
Machining
veneer
Derusting
metal
See Fig.
Sanding
A1-A8
metal and
steel
Sanding
curved
surface
Sanding
paper
180…400
40…120
120…240
60…240
180…240
40…120
120…240
60…240
Speed
3-6
4-6
1-5
1-6
See Fig.
G
3-5
4-6
4-6
1-6
13
See Fig.
Removing the Battery Pack
H
Emptying the Dust Bag
See Fig.
-For more efficient operation, empty
I1-I2
dust bag every 5-10 mins.
See Fig.
B1-B6
WORKING HINTS FOR YOUR
See Fig.
MULTI SANDER
C
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and
run it with no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speed. Always
See Fig.
use sand paper that is suitable for the material you
D
want to sand.
Always ensure the work-piece is firmly held or
See Fig. E
clamped to prevent movement.
Any movement of the material may affect the quality
of the sanding finish.
Start your sander before sanding and turn it off only
See Fig. F
after you stop sanding. For the best results, sand
wood in the direction of the grain.
Do not start sanding without having the sandpaper
fitted.
Do not allow the sandpaper to wear away it will
5-in-1 Multi Sander EN