Worx WX652, Инструкция по безопасности и эксплуатации

Страница: 9 / 12

Random orbital sander WX652 WX652.1
grit) for finishing. If you use a fine grade for
rough surfaces it will soon clog and need
changing.
— It is best to make a trial run on a scrap
piece of material to determine the optimum
grades of sandpaper for a particular job.
8. SANDING PlAtE bRAKE
An integrated sanding plate brake reduces the
speed when running at no load so that scoring
is avoided when placing the machine on the
work piece. A continuously increasing no-load
speed over the course of time indicates that
the sanding plate brake is worn and must be
replaced by an authorized customer service
location.
WORKING HINTS FOR YOUR
SANDER
If your power tool becomes too hot, especially
when used at low speed, set the speed to
maximum and run it with no load for 2-3
minutes to cool the motor. Avoid prolonged
usage at very low speeds. Always use sand
paper that is suitable for the material you want
to sand.
Always ensure the work-piece is firmly held or
clamped to prevent movement.
Any movement of the material may affect the
quality of the sanding finish.
Start your sander before sanding and turn it
off only after you stop sanding. For the best
results, sand wood in the direction of the
grain.
Do not start sanding without having the
sandpaper fitted.
Do not allow the sand paper to wear away
it will damage the base-plate. The guarantee
does not cover base-plate wear and tear.
Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and fine grit
for the final surfaces. If necessary, first make a
test run on scrap material.
Use only good quality sand paper.
The sand paper controls the sanding
efficiency, not the amount of force you apply
to the tool. Excessive force will reduce the
sanding efficiency and cause motor overload.
Replacing the sand paper regularly will
maintain optimum sanding efficiency.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never
use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep
all working controls free of dust. Occasionally
you may see sparks through the ventilation
slots. This is normal and will not damage your
power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid
a hazard.