Worx WX638, Инструкция по безопасности и эксплуатации, Страница: 8 / 13

WX638 WX638.1
WX640 WX640.1
Finishing sander
OPeratInG InStruCtIOnS
NOTE:
Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for dry sanding of wood,
plastic, filler and coated surfaces.
ASSEMbly
1. fIT THE SANDING PAPER
A) SANDING PAPER WITH HOOK & lOOP
SySTEM (for Wx638 Wx638.1)
(See fig. A1)
The sanding papers are placed directly onto the base
plate. The hole pattern in the sanding plate and sanding
paper must match.
Before placing on the sanding paper, free the base plate
from dust/debris by lightly tapping against it.
b) SANDING PAPER WITHOUT HOOK & lOOP
SySTEM (for Wx638 Wx638.1 Wx640)
(See fig. A2)
Lightly lift the clamp lever (5) and unlatch it.
Slide the sanding paper under the sand paper clamp
lever and reinsert the clamp lever (5).
Make sure that the sanding paper faces firmly against
the base plate. Fold the sanding paper around and
clamp the other end in the same manner.
Sanding paper without holes, e. g. from rolls or by the
meter, can be punctured with the paper punch for use
with dust extraction.
2. REMOVE THE SANDING PAPER
A) SANDING PAPER WITH HOOK & lOOP
SySTEM (for Wx638 Wx638.1)
Simply remove the sanding paper directly.
b) SANDING PAPER WITHOUT HOOK & lOOP
SySTEM (for Wx638 Wx638.1 Wx640)
To remove the sanding paper, lift up the clamp lever
and move away from the clamp lever lock. The sanding
paper clamp is now loose. Repeat with the other clamp
on the opposite side of your sander.
3. PAPER PUNCH
If using sanding paper without dust holes, use the
paper punch to perforate the holes to ensure correct
dust extraction. Position the punch (10) over the base
plate with the punch sides on the edges of the base
plate. Press the punch into the base plate to punch
1
2
A1
A2
B
C
2
12
13
12
1