Planer WX623.1
3
application.
The correct power tool will
do the job better and safer at the rate for
which it was designed.
2) Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be controlled
with the switch is dangerous and must be
repaired.
3) Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories,
or storing power tools.
Such preventive
safety measures reduce the risk of starting
the power tool accidentally.
4) Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool.
Power tools are
dangerous in the hands of untrained users.
5) Maintain power tools. check for
misalignment or binding of moving
parts, breakage of parts and any other
condition that may affect the power
tool’s operation. If damaged, have the
power tool repaired before use.
Many
accidents are caused by poorly maintained
power tools.
6) keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
7) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed.
Use of the power tool for
operations different from those intended
could result in a hazardous situation.
5. SeRvIce
1) Have your power tool serviced by
a qualified repair person using only
identical replacement parts.
This will
ensure that the safety of the power tool is
maintained.
aDDItIOnal Safety
WarnInG
1. Wait for the cutter to stop before
setting the tool down.
An exposed
rotating cutter may engage the surface
leading to possible loss of control and
serious injury.
2. Use clamps or another practical way
to secure and support the workpiece
to a stable platform.
Holding the work
by your hand or against the body leaves it
unstable and may lead to loss of control.
3. Hold the power tool by insulated
gripping surfaces only, because the
cutter may contact its own cord.
Cutting a “live” wire may make exposed
metal parts of the power tool “live” and
could give the operator an electric shock.
