11
Jigsaw WX472
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction
book carefully. Always wear a dust mask.
Recommendation that the tool always be
supplied via a residual current device with a rated
residual current of 30 mA or less.
INTENDED USE:
The machine is intended for sawing wood,
plastic, metal and building materials while resting
firmly on the workpiece. It is suitable for straight
and curved cuts with mitre angles to 45°. The saw
blade recommendations are to be observed.
Action
Figure
Blade Installation
See Fig A1
Blade Removing
See Fig A2
Variable speed control
See Fig B
Pendulum function
See Fig C
On/off switch
See Fig D
Lock-on button
See Fig D
Straight cut and curve cut
See Fig E1,E2
Bevel cut
See Fig F,G
Plunge cut
See Fig H
Parallel guide
See Fig I1,I2
Blade Storage
See Fig J
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrica-
tion or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be re-
placed by the manufacturer, its service agent
or similarly qualified persons in order to avoid
a hazard.
TROUBLESHOOTING
Symptom
Possible Causes
Possible Solution
Tool will not start when
power on
• Power cord is not plugged.
• Check to make sure power cord is
connected well into a working outlet.
Poor cut quality
• Blade is worn out.
• Blade is assembled incorrectly
• Pushing rate is too fast.
• Make sure the blade is sharp and
not broken.
• Make sure the blade is installed properly.
Push the machine slowly.
Work efficiency is low.
• Blade is worn out
• Incorrect speed setting
• Incorrect Pendulum function
setting
• Change to a new blade.
• Adjust the variable speed control
according to the material
• Adjust the pendulum function
control according to the material
Blade is not clamped
tightly by the Blade Holder.
• Blade is not inserted into
place fully.
Dismantle the blade and reinstall it
correctly.
Содержание WX472
