Worx WX390, Оригинальное руководство пользователя

Страница: 12 / 112

Cordless Rotary Hammer EN
12
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for hammer drilling in
concrete, brick and stone. It is also suitable for
drilling without impact in wood, metal, ceramic and
plastic. Machines with electronic control and right/
left rotation are also suitable for screwdriving.
OPERATION
ACTION FIGURE
Removing The Battery See Fig. A1
Inserting The Battery See Fig. A2
Selecting The Operating Mode See Fig. B
HAMMER DRILLING
Inserting Drill Bits See Fig. C1
Removing Drill Bits See Fig. C2
DRILLING & SCREWDRIVING
Inserting Adaptors See Fig. D1
Inserting Bits into Chuck See Fig. D2
Removing Adaptors See Fig. D3
Removing Bits from Chuck See Fig. D4
On/Off Switch See Fig. E
Switch Lock
NOTE:
The Switch Trigger Can Be
Locked In The Off Position.
See Fig. F
Forward Rotation Control See Fig. G
Reverse Rotation Control See Fig. H
LED Light See Fig. I
Temperature Dependent
Overload Protection
/
Protection Against Deep
Discharging
/
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes over heated, set the
speed to maximum and run no load for 2-3 minutes
to cool the motor. SDS-plus tungsten carbide
drill bits should always be used for concrete and
masonry.
When drilling in metal, only use HSS drill bits in
good condition. Where possible use a pilot hole
before drilling a large diameter hole.
PROBLEM SOLUTION
1. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, having not used a battery
pack for a prolonged time will reduce the battery
pack working time. This can be corrected after
several charge and discharge operations by charging
& working with your tool. Heavy working conditions
such as large screws into hard wood will use up
the battery pack energy faster than lighter working
conditions. Do not re-charge your battery pack below
0
o
C and above 30
o
C as this will affect performance.
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance, except for the cleaning & lubrication of
the SDS bits and adaptors before inserting into the
chuck. There are no user serviceable parts in your
power tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working
controls free of dust. Occasionally you may see
sparks through the ventilation slots. This is normal
and will not damage your power tool.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
DISPOSAL OF AN
EXHAUSTED BATTERY PACK
Li-Ion
To preserve natural resources, please recycle
or dispose of the battery pack properly. This
battery pack contains Li-ion batteries. Consult
your local waste authority for information
regarding available recycling and/or disposal
options. Discharge your battery pack by operating
your tool, then remove the battery pack from the tool
housing and cover the battery pack connections with
heavy-duty adhesive tape to prevent short circuit and
energy discharge. Do not attempt to open or remove
any of the components.