Worx WX126, Оригинальное руководство пользователя

Страница: 11 / 24

11
Lithium-ion cordless drill/driver EN
2. FittiNg AND rEmOviNg Bits (see c)
After removing the chuck, the tool can be used
as a screwdriver. To use any one of the short
bits supplied, insert the bit into the spindle.
To remove the bit, simply pull it out of the
spindle.
3. ON / OFF switch (see D)
Depress the On/Off switch to start and release
it to stop your drill. The on/off switch is fitted
with a brake function which stops your chuck
immediately when you quickly release the
switch.
It is also a variable speed switch that delivers
higher speed and torque with increased
trigger pressure. Speed is controlled by the
amount of switch trigger depression.
wArNiNg: Do not operate for
long periods at low speed because
excess heat will be produced internally.
4. switch LOck
The switch trigger can be locked in the OFF
position. This helps to reduce the possibility of
accidental starting when not in use. To lock the
switch trigger, place the rotation control in the
center position.
5. rEvErsiBLE (see D)
For drilling and screw driving use forward
rotation marked “
” (lever is moved to the
left). Only use reverse rotation marked “ ”
(lever is moved to the right) to remove screws
or release a jammed drill bit.
wArNiNg: Never change the
direction of rotation when the
chuck is rotating, wait until it has
stopped!
6. twO-sPEED gEAr cONtrOL (see D)
The drill has a two-speed gear control
designed for drilling or driving at LO (mark is
1) or HI (mark is 2) speeds. A slide switch is
located on top of the drill to select either LO
or HI speed. When using the drill in the LO
speed range, the speed will decrease and the
drill will have greater power and torque. When
using the drill in the HI speed range, the speed
will increase and the drill will have less power
and torque.
gear i
Low speed range: for screwdriving or working
with large drilling diameter
gear ii
High speed range: for working with small
drilling diameter
wArNiNg: to prevent gear damage,
always allow the chuck to come
to a complete stop before changing the
direction of rotation or the two-speed
gear control.
7. chuck ADjustmENt (see E)
To open the chuck jaws rotate the front sleeve
of the chuck. Insert the drill bit between the
chuck jaws and rotate the front sleeve in the
opposite direction. Ensure the drill bit is in the
center of the chuck jaws. Finally, firmly rotate
the front sleeve in the opposite directions.
Your drill bit is now clamped in the chuck.
8. tOrquE ADjustmENt (see F)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque
adjustment ring. The torque is greater when
the torque adjustment ring is set on a higher
setting. The torque is less when the torque
adjustment ring is set on a lower setting.
Make the setting as follows:
1 - 4 for driving small screws
5 - 9
for driving screws into soft
material
10 - 15
for driving screws into soft and
hard material
for heavy drilling
9. AutOmAtic sPiNDLE LOck (see g)
The automatic spindle lock allows you to use
it as a regular screwdriver. You can give an
extra twist to firmly tighten a screw, loosen