Worx WX092, Инструкция по безопасности и эксплуатации

Страница: 13 / 16

13
20V Multi-Function
Inflator
WX092
WX092.X
Power button
Press the button to turn on the tool
and hold the button to turn it off.
NOTE: To avoid unintentional start
up, the power button
will automatically shut down when
the Start/Stop button
is not pressed for a certain period
after the power button is turned on.
See Fig. B
Changing the unit of measure
Press INCREASE AIR PRESSURE
BUTTON and DECREASE AIR
PRESSURE BUTTON simultaneously
to change the unit of measure
See Fig. C
Setting the pressure
Press INCREASE AIR PRESSURE
BUTTONor DECREASE AIR PRESSURE
BUTTON to set the pressure value.
NOTE: Object’s original air pressure
will be displayed once connected.
Without connection, “0” will be
displayed
.
See Fig. D
Inflating
Connect the object to the tool. Then
press Start/Stop button. Once it
reaches the set pressure, the tool
will automatically stop
.
NOTE: Make sure all connections
have been tightened before inflating.
NOTE : In E2, loosen the locking nut
on the valve stem first.
WARNING : When inflating the
floating tube, check the status
of the tube rather than using the
pressure value on the gauge.
See Fig.
E1,E2,E3, E4
Work Light
Press the work light button to
cycle through work light or SOS
emergency light.
WARNING :
Do not look
towards the light directly.
See Fig. F
Storing adapter and hose See Fig. G1,G2
Battery protection system
The tool is equipped with a battery protection system.
The system will automatically cut off power to the tool
to extend battery life. The tool will automatically stop
during operation if the battery is placed under one of the
following conditions:
•
Overloaded
: The tool is operated in a manner that
causes it to draw an abnormally high current. In this
situation, turn the tool off and stop the application that
caused the tool to become overloaded. Then turn the tool
on to restart.
•
Low battery voltage
: The remaining Battery
capacity is too low and the tool will not operate. In this
situation, remove and recharge the Battery.
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
Positec Australia Pty Limited
10 Corporate Blvd Bayswater , VIC 3153, Australia
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Postfach 32 02 16, 50796 Cologne, Germany
Declare that the product,
Description Cordless air pump
Type Designation WX092 WX092.X (092-designation
of machinery, representative of Cordless air pump)
Function Inflating
Complies with the following directives,
2014/35/EU, 2014/30/EU,
2011/65/EU&(EU)2015/863
Standards conform to
EN 60335-1, EN 1012-1,
EN 62233, EN 55014-1, EN 55014-2
2022/02/08
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P. R. China