Worx WU364, Руководство пользователя

Страница: 12 / 32

Cordless Hammer Drill ENG
OPERATING INSTRUCTIONS
1. CHARGING YOUR BATTERY PACK
Warning:
The charger and battery pack
are specifically designed to work together
so do not attempt to use any other devices.
Never insert or allow metallic objects into your
charger or battery pack connections because an
electrical failure and hazard will occur.
2. BEFORE USING YOUR CORDLESS DRILL
Your battery pack is UNCHARGED and you must
charge once before use. Your battery pack will not
be fully charged until you have performed several
charge and discharge operations by charging &
working with your drill. After this your battery
pack performance will improve.
3. HOW TO CHARGE YOUR BATTERY
Charging procedure
1)Plug the charger into an appropriate outlet. The
red light (11) will flash for 1 second and then go
out.
2)Insert the battery pack into the charger , the
red light (11) will stay on to indicate the charging
process has started.
3)On completion of charge the red light (11) will
change to continuous green. The pack is now
fully charged ,unplug the charger and remove
the battery pack
Charging indicator
This charger is designed to detect some problems
that can arise with battery packs. Indicator lights
indicate problems (see table below). If this
occurs, insert a new battery pack to determine
if the charger is OK. If the new battery charges
correctly, then the original pack is defective and
should be returned to a service center or recycling
service center. If the new battery pack displays
the same problem as the original Battery Pack,
have the charger tested at an authorized service
center.
Light
ON/OFF
flash
Status
Red on Charging
Red slow
flash
- - - - - Dead battery
Red fast
flash
-------------
Battery failure or
charger invalidated
Green on Charging complete
Green
slow flash
- - - - -
Hot/Cold delay; weak
battery repair; battery
abnormal
Green fast
flash
-------------
Charging battery too
hot
Hot/cold battery pack delay
This charger has a
HOT/COLD
battery pack
delay feature. When the charger detects a
battery pack that is too hot or cold (the green
light will flash slowly), it automatically starts a
HOT/COLD
Pack Delay, and suspends charging
until the battery pack has reached the correct
temperature. The charging process will then
automatically begin (red light ON continuously).
This feature ensures maximum battery life.
Leaving the battery pack in the charger
If a fully charged battery pack is left in the
charger, the green light (10) will remain ON. The
battery pack will remain charging with a current
of about 150mA.
Note:
A battery pack will slowly lose its charge
when kept out of the charger or left in an
unplugged charger. It may need to be recharged
before use.
Weak battery packs
This charger will detect a weak battery pack.
When a weak battery pack is inserted into the
charger, the charger will try to repair it. This
process will last about 30mins (the green light
will flash slowly). When the repair is finished, it
will automatically begin to charge the battery
pack to the highest capacity possible (the red
light stays ON). If the green light (10) flashes for
more than 30mins, the red light (a) will begin to
flash slowly indicating the battery pack is dead.
NOTE Repaired battery packs are still usable
but should not be expected to perform as much
work as new battery packs.
13 12
RUS-WU364 WU366-M-060818.indd 12 2006-8-18 17:52:40