Worx WU330, Оригинальное руководство пользователя

Страница: 8 / 126

8
1
2
Operating instructions
Note: Before using the tool, read the instruction book carefully.
INTeNDeD Use
The machine is intended for hammer drilling in concrete, brick and
stone as well as for light chiseling work. It is also suitable for drilling
without impact in wood, metal, ceramic and plastic.
CHANGING THe DRILL CHUCK (see Fig. A1, A2)(WU330.2 WU330.3)
• Removing the replacement drill chuck (see Fig. A1)
Warning: Before removing the replacement drill chuck,
always remove the tool or bit! With the drill pointing toward you,
grasp the locking ring (7) of the SDS-plus “quik-change” chuck and
pull forward firmly, then rotate it to the side. The SDS-plus “quik-
change” chuck will come free.
• Attaching the replacement drill chuck (see Fig. A2)
When mounting the precision keyed (12.1) /keyless chuck (12.2),
grasp the precision keyed (12.1)/keyless chuck (12.2) with the whole
hand, push it as far as it will go, then rotate it to the side until it can
clearly be heard to latch. The precision keyed (12.1)/keyless chuck
(12.2) locks itself. Check locking by pulling on the precision keyed
(12.1)/keyless chuck (12.2). Make replacements in a corresponding
manner.
INseRTING/RePLACING THe DRILL CHUCK (see Fig. B)
• Inserting the drill chuck
To work with tools without SDS-plus (e.g., drills with cylindrical
shafts), a suitable drill chuck must be used. Insert the adapter (14)
of the drill chuck (13) with a twisting motion into the SDS-plus chuck
Symbols
To reduce the risk of injury, user must read instruction
manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling
advice.