Worx WG401E, Инструкция по безопасности и эксплуатации

Страница: 8 / 12

Silent shredder WG401E
8
This prevents the cutting roller (12) from clogging.
Do
not mulch soft waste without solid substance
such as kitchen waste. this material should be
composted directly.
The mulching of dry hardwood branches with the
maximum allowable diameter is also possible with a
sharp cutting roller (12).
MALFUNcTIONS
WARNING! Before switching the rotational
direction, always switch the machine off and
wait until it stops.
Garden waste does not feed by itself:
• The cutting roller (12) is running backward: Switch
rotational direction.
• The material to be mulched is soft and wet: Push into
machine with a piece of wood or change to mulching
branches.
• The material to be mulched jams in the feed opening (1):
Place rotational direction switch (8) in the left position to
free the material.
thick branches are not pulled in:
• Check cutting roller (12): If heavily worn, it must be
replaced.
Motor does not run:
Check the overload protection, reset the overload
protector.
Check the house fuse. The circuit must be protected with
at least 13A fuse
Direction of rotation switches automatically:
When the machine is suddenly blocked (e. g. owing to
accumulated mulched material), the direction of rotation
of the cutting roller switches automatically. In this case
switch the machine off, wait until it stops and switch it on
again.
cutting Roller is blocked
1. Place rotational direction switch (8) in the left position,
switch machine on. The cutting roller (12) runs backwards
and releases the mulched material (or foreign material). A
special gear construction with rotational angle play allows
the motor to start in the opposite rotational direction even
if the cutting roller (12) is blocked. It is not necessary to
loosen and readjust the pressure plate (11).
2. When the caught material is free, switch off machine,
set rotational direction switch (8) to the right position and
switch back on.