Worx WG303E, Инструкция по безопасности и эксплуатации

Страница: 14 / 24

Chain Saw WG303E
14
2. CHAIN STOP lEVER (HAND GUARD) (See fig.
G1)
The Chain Stop Lever (Hand Guard) (5) is a safety
mechanism that causes the Chain (8) to quickly stop. In
many cases when kickback occurs the operator’s hand
strikes the Chain Stop Lever (Hand Guard) causing it
to activate. When activated, the moving Chain quickly
stops.
The following function check should be carried
out at regular intervals.
Push the Chain Stop Lever
(hand guard) (5) forwards (position ) and start the chain
saw. The Chain should not move. To deactivate the Chain
Stop Lever, release the On/Off Switch (2) and pull the
Chain Stop Lever (Hand Guard) backwards (position )
(See Fig. G1).
CUTTING
IMPORTANT:
Is the oil reservoir filled? Check the
Oil Level Window (19) prior to starting and
regularly during operation. Refill oil when oil level is
low. A full oil tank will last approx. 20 minutes
depending on sawing intensity and stops (See Fig. G2).
Check recent replaced chain tension about every 10
minutes during operation.
1. Connect saw to extension cord. Connect extension
cord to power supply (See Fig. G3).
2. Make sure section of log to be cut is not laying on
the ground. This will keep the chain (8) from touching
the ground as it cuts through the log. Touching the
ground while the Chain is moving is dangerous and
will dull the Chain.
3. Use both hands to grip saw. Always use left hand to
grip front handle and right hand to grip rear handle.
Use a firm grip. Thumbs and fingers must wrap
around saw handles (See Fig. H).
4. Make sure your footing is firm. Keep shoulder width
feet apart. Divide your weight evenly on both feet.
5. When ready to make a cut, push the Lock-off Button
completely in with the right thumb and squeeze the
trigger. This will turn saw on. Releasing the trigger
will turn the saw off. Make sure the saw is running at
full speed before starting a cut.
6. When starting a cut, slowly place moving chain
against the wood. Hold saw firmly in place to avoid
possible bouncing or skating (sideways movement)
of saw.
7. Guide the saw using light pressure and do not put
excessive force on the saw. The motor will overload
and can burn out. It will do the job better and safer at
the rate for which it was intended.
1
1
2
5
G1
19
G2
G3
H