Worx Sonicrafter WX678, Руководство пользователя

Страница: 10 / 120

Oscillating Tool EN
10
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
INTENDED USE:
The power tool is intended for sawing and
remodelling wooden materials, plastic, plaster,
non-ferrous metals and fasteners (e.g. nails and
clamps) as well as for working on soft wall tiles and
for dry grinding of small surfaces. It is especially
suitable for working close to edges and for flush
cutting.
ASSEMBLY AND OPERATION
Action Figure
Mounting accessories See Fig. A-C
Mounting the sanding sheet See Fig. D
Mounting the suction device
(not supplied)
See Fig. E1-E5
Operating the on/off switch See Fig. F
Using the variable speed dial See Fig. G
Remove or install battery pack See Fig. H
LED Light See Fig. I
The Variable Speed Dial can be used to set the
optimum oscillating frequency according to the
accessories used and the respective application.
Oscillation
frequency
Application
High oscillation
frequency:
Sanding, Sawing, Rasping
and Polishing Stone and
Metal.
Low oscillation
frequency:
Scraping, Polishing
Varnishes.
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and
run it with no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds. Always
keep the blade sharp.
Always ensure the workpiece is firmly held or
clamped to prevent movement.
Any movement of the material may affect the quality
of the cutting or sanding finish.
Start your tool before working and turn it off only after
you stop working.
Do not start sanding without having the sandpaper
fitted.
Do not allow the sandpaper to wear away , it will
damage the sanding pad. The guarantee does not
cover sanding pad wear and tear.
Use coarse grit paper to sand rough surfaces, medium
grit for smooth surfaces and fine grit for finishing
surfaces. If necessary, first make a test run on scrap
material.
Excessive force will reduce the working efficiency
and cause motor overload. Replacing the accessory
regularly will maintain optimum working efficiency.
MAINTAIN TOOLS WITH
CARE
Your power tool requires no additional lubrication
or maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry
place. Keep the motor ventilation slots clean. Keep all
working controls free of dust. Occasionally you may
see sparks through the ventilation slots. This is normal
and will not damage your power tool.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0°C -45°C.
The recommended ambient temperature range for the
charging system during charging is 0°C-40°C .
ENVIRONMENTAL
PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.