Worx MAKER X WX741L Series, Руководство пользователя

Страница: 14 / 40

14
EN
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction book carefully.
ASSEMBLY
1. Mount the guard as needed. (See Fig.A1)
Press and hold the spindle lock button, assemble the wheel and flange, then use the
hex key to tighten. (See Fig. A2)
NOTE:
Always ensure the workpiece is firmly held or clamped to prevent movement.
The angle grinder can work with Butterfly-style arbors such as the EZ-Lock ® discs
of Dremel®. Dremel and EZ-Lock are trademarks of Robert Bosch Tool Corporation.
(See Fig. A3)
2.Connect the angle grinder to the hub. (See Fig. B)
WARNING: Before operation, make sure the speed control button on the
hub is at the“Min“ position. (See Fig. C)
OPERATION
1. Confirm the speed control button is set to “Min”. Grasp the tool by the grip. Press
the on/off switch on the hub to start the machine. (See Fig. D)
CAUTION:
Do not use damaged or worn accessories. Make sure the machine is in
perfect condition.
NOTE:
Always start at no load to achieve maximum speed then start working. Do not use
excessive contact pressure! A correct and uniform speed enables better performance.
2.Adjust speed as needed. (See Fig. E)
NOTE:
After usage, press the on/off switch on the hub to turn off the machine and
disconnect it from the hub. For sake of safety, adjust the speed control button to
“Min” position once completing the operation.
3.Replace the disc. (See Fig. F)
Press and hold the spindle lock button and use the hex key to loosen.
NOTE:
Before changing the accessory, make sure your machine is turned off and
disconnected from the hub or battery.
NOTE:
2 spare screws for the guard, and 1 spare blade flange have been included
with your tool, in case the original pieces become lost.
WARNING:
Never use a cutting disc for roughing.
MAINTENANCE
Remove the battery pack from the tool before carrying out any adjustment,
servicing or maintenance.
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a dry cloth. Always store your
power tool in a dry place. Keep the motor ventilation slots clean. Keep all working
controls free of dust. Occasionally you may see sparks through the ventilation
slots. This is normal and will not damage your power tool.