Worx HYDROSHOT WG620E, Инструкция по безопасности и эксплуатации, Страница: 17 / 24

17
2 in 1: Portable Power Cleaner/Water Sprayer
WG620E WG620E.X
NOISE DATA
A weighted sound pressure L
pA
: 73.8 dB(A)
A weighted sound power L
wA
: 84.8 dB(A)
K
pA
2.35 dB(A)
Wear ear protection
VIBRATION INFORMATION
Typical weighted vibration
a
h
= 1.339 m/s 2
K= 1.5 m/s 2
The declared vibration total value may be used for
comparing one tool with another, and may also be used in
a preliminary assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool is
used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained
Using the correct accessory for the tool and ensuring it is
sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use should
also take account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle but not actually doing the job. This may
significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration exposure risk.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
This tool is intended for cleaning and watering.
ASSEMBLY & OPERATION
ACTION FIGURE
BEFORE OPERATION
Installing the battery pack See Fig. A1
Removing the battery pack See Fig. A2
Checking the battery condition
NOTE: Fig. A3 only applies for the battery
pack with battery indicator light.
See Fig. A3
Charging the battery pack
More details can be found in charger’s
manual
See Fig. A4
ASSEMBLY
Way 1:
Attaching pressure cleaning lance to the
power nozzle
NOTE: When attaching, align the two
projections on the lance with the grooves of
the power nozzle as shown in Fig. B1.
See Fig. B1
Way 2:
Attaching short lance to the machine
NOTE: When attaching, align the two
projections on the lance with the grooves of
the machine as shown in Fig. B2.
See Fig. B2
Way 3:
Attaching extension lance to the power
nozzle, then attaching the short lance to the
extension lance
NOTE: When attaching, align the two
projections as shown in Fig. B3 and Fig. B4.
See Fig. B3,
B4
Attaching the spray nozzle
NOTE: When attaching, rotate the nozzle
left and right to make sure the nozzle fully
seated into position and gently pulling it to
make sure it is locked into position securely.
Please choose the right nozzle according to
the working conditions.
See Fig. C2
Attaching the hose to the power nozzle and
use it with foldable water bucket or throw it
into other water sources
NOTE: After the hose is attached, check the
connection by gently pulling upon the hose.
It should not be pulled off.
See Fig. D1,
D2