Worx Professional WU189, Руководство пользователя

Страница: 12 / 20

EN
12
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
ASSEMBLY AND OPERATION
ACTION FIGURE
BEFORE OPERATION
Checking the battery charge
condition
See Fig.
A1
Removing the battery pack
See Fig.
A2
Charging the battery
See Fig.
A3, A4
Installing the battery pack
See Fig.
A5
ASSEMBLY
CHUCK ADJUSTMENT
Warning :
Always lock off
trigger switch and disconnect
tool from power source when
changing accessories. Always ensure
the bit is secure before starting the
tool. Damage to the Chuck or a loose
bit may cause possible personal
injury.
Removing the bits
See Fig.
B1
Inserting the bits
See Fig.
B2
Assembling the belt hook and bit clip
See Fig.
C1, C2,C3,
C4
OPERATION
Forward/reverse rotation
control
Warning
:
Never change the
direction of rotation when the
chuck is rotating, wait until it has
stopped!
See Fig.
D1, D2,
D3
TWO-SPEED GEAR CONTROL
See Fig. E
TORQUE ADJUSTMENT
SCREWDRIVING 1-22
DRILLING
HAMMER DRILLING
See Fig. F
Operating the on/off switch
Warning
:
Do not operate for
long periods at low speed
because excess heat will be
produced internally.
See Fig. G
LED light indicator
Before operation, the LED light
will be activated when the On/Off
switch is slightly pressed, and will
automatically turn off 20 seconds
after the On/Off switch is released.
The tool and battery are equipped
with a protection system. When
the LED Light is quickly flashing 3
seconds and turn off, the system will
automatically cut off power to the tool
to extend battery life. The tool will
automatically stop during operation
if the tool and/or battery are placed
under one of the following conditions:
• Overloaded:
The tool is operated
in a manner that causes it to draw
an abnormally high current. In this
situation, release the Trigger Switch
on the tool and stop the application
that caused the tool to become over-
loaded. Then pull the Trigger Switch
again to restart.
• Overheated:
Under the condition
above, if the tool does not start, the
Tool and Battery are overheated. In
this situation, let the Tool and Battery
cool before pulling the Trigger Switch
again.
• Low battery voltage:
The
remaining Battery capacity is too low
and the tool will not operate. In this
situation, remove and recharge the
Battery.
Warning:
To turn on the light, press the
On/Off switch and make sure the
Forward/Reverse Rotation Control is
on right/left position.