Worx Professional Sonicrafter WU678, Руководство пользователя

Страница: 8 / 34

8
MOUNTING / CHANGING THe sANdING sHeeT (see Fig. e )
Align the sanding sheet and press it onto the sanding pad by hand.
Firmly press the power tool with the sanding sheet against a flat
surface and briefly switch the power tool on. This provides for good
adhesion and prevents premature wear.
If one point has become worn, pull off the sanding sheet, turn it 120°
and place it on again.
Note: For other various brands’ sanding pad, use smaller flange
provided.
MOUNTING THe sUCTION deVICe (see Fig. F-J )
When vacuuming, mount the suction device as shown in F-J.
NOTe:
Using the sanding pad perforated. You can only do the
vacuuming after fitting the dust collector.
OPeRATING THe ON/OFF sWITCH
To start the machine, push the On/Off switch forward so that the “I”
is indicated on the switch.
To switch off the machine, push the On/Off switch toward the rear
so that the “0” is indicated on the switch.
UsING THe VARIABLe sPeed CONTROL
Select oscillation frequency (speed) while the motor is running.
The Variable Speed Control can be used to set the optimum
oscillating frequency according to the accessories used and the
respective application.
High oscillation frequency:
Sanding, sawing, rasping and polishing stone and metal.
Low oscillation frequency:
Polishing varnishes.
2
3
4
5
sANdING
Typical application: wood, metal; small areas, especially corners,
edges and places difficult to access.
Select high oscillation frequency.
Sand with a constant movement and light pressure.
Heavy pressure does not increase the removal – the sanding sheet
merely wears faster.
sAWING WITH THe seMICIRCLe sAW BLAde
The workpiece must be inserted firmly or clamped tightly before it is
cut.
Typical application: wood, PVC, soft metal sheet.
Select high oscillation frequency.
The saw blade lasts longer if the wear is distributed evenly. To ensure
an even distribution, loosen the saw blade, rotate it and retighten
firmly.
sAWING WITH THe UNIVeRsAL eNd CUT sAW BLAde
(see Fig. K)
Warning: The sawing teeth are very sharp. do not touch
during mounting and application.
The workpiece must be inserted firmly or clamped tightly before it is
cut.
Typical application: wood, metal (e. g. nails),plaster board and soft
plastics.
When plunging and sawing use a slight pendulum motion, to allow
sufficient chip removal.
sCRAPING
Typical application: Scraping off old varnish or adhesives, removing
glued carpeting, e. g. on stairs or other small to medium-sized surfaces.
Select medium / high oscillation frequency.
6
7
8
9