Worldlawn KING COBRA WYK52FX801V5, Руководство оператора

Страница: 26 / 48

26
CHECK ENGINE OIL LEVEL
Check the engine oil daily before starting the
engine otherwise shortage of the engine oil may
cause serious damage to the engine such as
seizure.
•
Place the engine on a level surface. Clean
area around the oil gauge before removing it.
•
Remove the oil gauge and wipe it with a clean
cloth.
•
Reinsert the oil gauge to check the oil level.
The level should be between “ADD” and “FULL”
marks. Do not overfill.
•
Install and tighten the oil gauge
CAUTION
Do not fill above the “FULL” mark. Excess oil
will cause a smoking condition, and may cause
the engine to overheat.
CHECK BATTERY CHARGE
Service Interval: Monthly
IMPORTANT INFORMATION
Do not attempt to open or remove caps or
covers. Adding or checking level of electrolyte
is not necessary.
Always use two wrenches for the terminal
screws.
WARNING
Do not short battery terminals by allowing a
wrench or any other object to contact both
terminals at the same time. Before connecting
battery, remove metal bracelets, wristwatch
bands, rings, etc.
Positive terminal must be connected first to
prevent sparks from accidental grounding.
WARNING
CALIFORNIA PROPOSITION 65
BATTERY POSTS, TERMINALS, AND RELATED
ACCESSORIES CONTAIN LEAD AND LEAD
COMPOUNDS, CHEMICALS KNOWN TO THE
STATE OF CALIFORNIA TO CAUSE CANCER
AND REPRODUCTIVE HARM. WASH HANDS
AFTER HANDLING.
Allowing batteries to stand for an extended period
of time without recharging them will result in
reduced performance and service life. To preserve
optimum battery performance and life, recharge
batteries in storage when the open circuit voltage
drops to 12.4 volts.
NOTE: To prevent damage due to freezing, battery
should be fully charged before putting away for
winter storage.
Check the voltage of the battery with a digital
voltmeter. Locate the voltage reading of the battery
in the table and charge the battery for the
recommended time interval to bring the charge up
to a full charge of 12.6 volts or greater.
IMPORTANT: M ake sure the negative battery
cable is disconnected and the battery charger
used for charging the battery has an output of
16 volts and 7 amps or less to avoid damaging
the battery (see chart for recommended charger
settings).
Voltage
Reading Percent
Charge Maximum
Charger
Settings Charging
Interval
12.6 or
greater 100% 16 volts/7
amps No
Charging
Required
12.4
– 12.6
75%-100% 16 volts/7
amps 30 Minutes
12.2
– 12.4
50- 75% 16 volts/7
amps 1 Hour
12.0
– 12.2
25
– 50%
14.4 volts/4
amps 2 Hours
11.7
– 12.0
0
– 25%
14.4 volts/4
amps 3 Hours
11.7 or less 0% 14.4 volts/2
amps 6 Hours or
More