Worldlawn 28?, Руководство оператора

Страница: 6 / 16

Adjustment & Repairs
3
hillsides.
●
Do not operate the mower under the influence of alcohol or drugs.
●
Before leaving the operator’s position or leave the mower unattended,
shift the transmission into neutral, place the neutral latches in the neutral
lock position, and release the Blade Drive Lever. Shut the engine off.
●
Shut the engine off and wait until the blades come to a complete stop
before removing the grass catcher.
●
Never raise the mower deck while the blades are rotating.
●
Always park the mower and/or start the engine on a level surface.
●
Do not pass or stand on the grass discharge side of any mower while
the engine is running. Stop operation when another person approaches.
FIG4.
FIG4
MAINTENANCE AND STORAGE
Allow only trained personnel to service the mower.
●
Disconnect the spark plug wire from the spark plug to prevent
accidental starting of the engine when servicing, adjusting or storing the
mower.
●
If the mower must be tipped to perform maintenance or adjustment,
drain the gasoline from the fuel tank.
●
To reduce potential fire hazard, keep the engine free of excessive
grease, grass, leaves and accumulations of dirt.
●
Be sure the mower is in safe operation condition by keeping nuts,
bolts, and screws tight. Check the blade bolts and nuts frequently to be
sure they are tight.
●
If the engine must be running to perform a maintenance adjustment,
keep hands, feet, clothing and other parts of the body away from the
blades and other moving parts.
●
Do not overspeed the engine by changing governor settings. To be
sure of safety and accuracy, have an authorized dealer check maximum
engine speed with a tachometer.
●
The engine must be shut off before checking the oil or adding oil to
the crankcase.
●
Allow the engine to cool before storing the mower in any enclosure
such as a garage or storage shed.
●
Always store gasoline in a safety-approved, red container.
●
Caution must be taken while maintenance is being made to battery.
Battery with corrosive acid can burn your skin and cloth.
●
Keep battery away from fire, short circuit of battery can cause
explosion.
●
Drain and refill the transmission oil yearly- use one pint of SAE30
●
Grease Fittings are provided on important parts requiring lubrication.
FIG17
MOWER OPERATION
CAREFULLY READ AND UNDERSTAND ALL SAFETY
INSTRUCTIONS BEFORE ATTEMPTING TO OPERATE THE
MOWER.
INITIAL RUN PROCEDURES
·
Check the belts for proper tension at 2, 4 and 8 hours.
·
Check the steering control rods for neutral adjustment .
·
Check the tires for proper pressure.
Drive wheels: 20 PSI (140kPa)
·
Check for loose hardware. Tighten as needed.
·
Check the safety switches for proper adjustment:
The engine will crank, but not start if the mower is not in
neutral.
The engine will crank, but not start if the blade drive lever
is engaged.
The engine should start if the transmission is in neutral and
the blade drive lever is disengaged.
·
Check to make sure that all the fittings have been lubricated
MOWER OPERATION
READ AND UNDERSTAND THE SAFETY INSTRUCTIONS
BEFORE ATTEMPTING TO OPERATE THE MOWER
BEFORE STARTING THE ENGINE
Check oil level in the engine.
Fill the fuel tank with clean, lead-free gasoline.
Open the fuel line shut-off on the bottom of the fuel tank.
NOTE:
·
The transmission must be in neutral.
·
The blade drive lever must be disengaged.
·
Operator presence levers must be released.
·
Steering levers must be in the neutral lock position.
START THE ENGINE
When starting a cold engine, move throttle control to choke position.
When restarting a warm engine , move throttle control to a mid position.
BLADE DRIVE