background image

M29112016H1 a.0

Insert the antenna:  Insert the antenna into the hole at the top of the controller, and tighten 

it. Extend the antenna to its maximum length. The range of the transmitter is 5 meters.

Install the batteries: 

On the transmitter: Remove the screw to open the battery compartment cover; insert 4 AA 

batteries in the battery compartment with correct polarity; close the battery compartment.

On the jet-ski: Remove the screw from the front of the jet-ski to open the battery compartment; 

insert 1 AAA battery in the battery compartment with correct polarity; close the jet-ski’s cover.

NOTE: Make sure that the safety rubber is positioned so that the seal is hermetic.

CAUTION!: Do not place hands near the propeller.

EN

PREPARATION

TRANSMITTER FUNCTIONS

+8

INSTRUCTION 

MANUAL

Function light

Left Propeller

Right Propeller

LEFT BUTTON

RIGHT BUTTON

MOVEMENTS

TROUBLESHOOTING

SPECIAL TIPS

USE RECOMENDATIONS

CAUTION

If some water enters in the interior of the jet-ski it can not work in a normal way.

Please stop using the jet-ski inmediately, unscrew the screw on the bottom and separate the 

jet-ski’s body. 

Dry the jet-ski with an electric hair dryer and fix the screws.

Battery warnings:

- Non-rechargeable batteries are not to be recharged.

- Rechargeable batteries must be removed before being 

charged. (Transmitter only)

- Rechargeable batteries have to be charged only under an 

adult supervision.

- Batteries have to be inserted with correct polarity.

- Exhausted batteries have to be removed from the toy.  

(Transmitter only)

- The supply terminals are not to be short-circuited.

- Do not mix old and new batteries. (Transmitter only)

- Only batteries of the same or equivalent type as recommended 

must be used. Do not mix alkaline, standard (carbon-zinc) or 

rechargeable (nickel-cadmium) batteries. (Transmitter only)

Through this Worldbrands SL declares that the toy meets the essential requirements and other 

relevant provisions of the Directive 1999/5 / EC.

You can view the Declaration of Conformity, Doc Jet Surfer XT580738, on the following link:

http://www.worldbrands.es/es/declaraciones-de-conformidad

WorldBrands: 

C/ Pouet de Nasío 

s/n parcela 5 nave B2 Sector 14. 

46190 - Ribaroja del Turia (Valencia, 

Spain)

• 

Select clear, streamless waters.

• 

Use it in pools or shallow ponds.

• 

Do not use this toy in salt water, it can cause 

damage the rotor.

• 

Do not operate the toy in swimming pools 

or places where people are swimming, it 

may hurt someone.

• 

Dry the toy with a cloth after playing.

• 

When you finish playing remove the batteries. 

• 

Do not leave the toy for long periods of time 

near sources of heat or in direct sunlight; and 

avoid leaving the toy nor the transmitter all 

night outdoors.

• 

Interference from high voltage lines, radios or 

other toys may occur with the same frequency. 

If this happens look elsewhere without inter-

ference to play. 

PROBLEM

CAUSE

SOLUTION

The jet-ski is not 

responding

- The battery may be low

- Controller may be low on battery

- The controller and the jet-ski may not 

be paired correctly

- Replace the battery in the jet-ski

- Replace the batteries in the controller

- Remove the batteries and place 

them again.

The jet-ski responds 

slowly

- Controller batteries may be low

- A controller using the same  

frequency may be in use nearby

- Replace the batteries

- Move to another area outside of the 

other controller

Care and maintenance:

- Take off the batteries from the transmitter if the vehicle has 

not been used for a long period of time.

- After each usage, clean and dry the inside of the jet-ski.

- Never leave the product under a direct hot source.

Power supply:

Rating:

Batteries:

DC 1,5V

1 x 1.5V AAA/LR03 

(Not included)

JET-SKI

Power supply:

Rating:

Batteries:

DC 6V

4 x 1.5V AA/LR6/AM3 

(Not included)

TRANSMITTER

FRESHWATER USE ONLY. 

ALWAYS AVOID SALT WATER.

Отзывы: