20
2
2
World Cat 230DC Owner’s Manual
33
6.10.16 Livewell and Livewell Pump
The livewell on your 230DC has a capacity of 30 gallons. It is equipped with a dual purpose livewell pump
and adjustable flow regulator. The pump is located in the port bilge compartment, can be activated by a
toggle switch on the dash switch panel, and can be reached through the inspection port in the motorwell.
The wiring is secured to the pump using a tie-strap and must be disconnected prior to removing the pump.
The livewell pump draws water through the high speed pickup mounted on the inboard
side of the port sponson. A seacock is installed between the pickup and the pump to allow
you to seal the system between use, or in the event of a plumbing failure. To operate the
livewell, first verify that the seacock and flow regulator are open, then install the drain
plug in the bottom of the tub. When you have completed these steps, engage the livewell
pump using the switch at the dash.
Water will fill the tank until it is level with the
overboard drain, which evacuates water through the hullside. To clear bait residue from the
tank during operation, temporarily remove the drain plug. When you have finished using
the livewell, remove the drain plug
to allow the water to drain overboard.
6.10.17 Windshield
The center windshield panel should be closed and latched at any time the boat is
underway.
NOTICE
While underway, leaving your livewell seacock open could result in inadvertently filling your livewell.
To prevent this, close the seacock when the pump is not in operation.
NOTICE
Operating the engines in reverse can cause excessive ventilation near the livewell intake, causing the
pump to airlock. To prevent this, turn the pumps “OFF” prior to any continuous or high speed reverse
operation. If your pump does becomes air locked, turn the pump “OFF” for 15 to 30 seconds to
correct the problem.
Deck Pump Out
Upon returning, use the following instruction to empty the holding tank:
•
Remove the cap from the deck pump-out fitting located on deck, outboard of the helm position.
•
Use the vacuum hose at the pump-out station to clean the tank, then remove the hose and replace
the deck fitting.
Overboard Discharge
Use the following steps to discharge the contents of the holding tank overboard:
•
Open the overboard discharge seacock which is located inside the aft hatch in the head. The seacock
must be in the open position before attempting to discharge the waste from the waste tank. Use the
key switch located on the head switch panel to evacuate the tank.
•
Inspect the tank level and repeat if needed, otherwise close the discharge seacock.
!!! CAUTION
Discharging waste in inland waters and some coastal areas is illegal. Check with local and state
authorities in your region to determine the proper method for waste disposal.
Содержание 230DC 2022
