World Cat 2013 320EC, Руководство пользователя

Страница: 58 / 109

2013 World Cat 320EC Owners Manual
3. Hold down the flush lever for 5 seconds to evacuate the bowl.
1.1.1.2.Normal Use
Use the steps below for normal operation.
1. Fill 1/3 of the bowl with water by lifting up on the flush lever
2. Hold down the flush lever for 5 seconds to evacuate the bowl.
Page 10-57
!
!
C
C
A
A
U
U
T
T
I
I
O
O
N
N
Large quantities of waste or paper can clog the head and cause odor issues. To prevent this, flush
often and if necessary perform an extra flush to purge the discharge line.
!
!
C
C
A
A
U
U
T
T
I
I
O
O
N
N
Do not dispose of foreign objects in the head. Doing so may damage the outlet hoses. Clogging or
puncturing these lines will lead to odor problems.
1.1.1.3. DECK PUMP-OUT
Upon returning, use the following instruction to empty the holding tank.
1. Remove the cap from the deck pump-out fitting located on the deck, forward of the starboard fuel fill.
2. Use the vacuum hose at the pump-out station to clean the tank, then remove the hose and replace the deck
fitting.
1.1.1.4.Overboard Discharge
Use the following steps to discharge the contents of the holding tank overboard:
1. Remove the access plate located behind the head to open the discharge seacock.
2. Using the TankMaster™ panel, turn the key switch to “manual” to engage the macerator pump. Hold the
key in this position until the Tank Watch™ panel reads empty.
3. Close the discharge seacock and replace the access plate.
!
!
C
C
A
A
U
U
T
T
I
I
O
O
N
N
Discharging waste in inland waters and some coastal areas is illegal. Check with local and state
authorities in your region to determine the proper method for waste disposal.
For more instructions on operation, winterization and troubleshooting the marine head, see the Vacu-Flush™ manual supplied
in your “Owner’s Portfolio”.
10.1.9 SHOREPOWER PACKAGE
The 320EC comes equipped with a shorepower package which includes a shore power inlet and cordset (30 Amps),
AC distribution panel, refrigerator, microwave, five (110 V) receptacles, electric stove, water heater and battery
charger. Following are instructions on the function and proper use of these accessories.
1.1.1.5.Connecting Shore Power
The shore power inlet is located on the outboard vertical wall of the starboard motorwell. Use the following
steps to help protect your vessel and yourself.
• Before connecting the cordset, turn the “AC Main” breaker and all accessory breakers to the “OFF”
position. The breakers are installed on the AC panel located on the upper galley cabinet in the cabin.