6
CUSTOMER SERVICE
UK: 0800 / 328 6020
[email protected] GT-MM-10, 09/13, E46106
Ireland: 00800 / 4467 5888
Detecting hidden objects
CAUTION
In order to avoid personal injury or property damage, please note the
following:
– Beams/girders are built into brickwork at regular distances. Determine
the distance of the beams/girders prior to working on brickwork.
– Irregularities in the distances indicate e.g. electric cables or water lines.
– Measurement errors can occur based on the surface condition.
– If you detect something, always check whether it is an electric cable.
– If the lightning symbol appears in the display, it is a conductive electric
cable.
– Static charges can extend the coverage area of an electric cable by up to
30 cm.
– Do not carry out any work on brickwork in this area.
– Work is only permitted in the area of electric cables, once the power
supply is disconnected at the consumer unit. If in doubt seek the advice
of an electrician.
– The detected object can be wider or narrower than shown in the display,
depending on the depth.
– Always mark the start and end of the object. The middle between both
marks is then the middle of object.
The following objects (materials) can be detected with the device:
Wood/beams (
STUD
), maximum detection depth 19mm
Metal (
METAL
), maximum detection depth 30mm
With the (
DEEP
) setting, particularly deeply positioned beams/wood and metal
parts can be detected (max. detection depth 38 mm)
Electric cables (
AC
), maximum detection depth 50mm
Select mode
Press the
MODE
button to select the required mode
STUD
>
METAL
>
DEEP
>
AC
.
Calibrating device
The device must be calibrated to the characteristics of the body (wall, floor,
ceiling):
prior to the start of each search
regularly during a search process (after every 60 seconds)
Multi Sensor UK WORKZONE E46106.book Seite 6 Montag, 22. April 2013 1:20 13