8. DIGITAL INPUTS
A se ng important to the S.BUS port is the
S.BUS O set
. Since S.BUS has up to 16 channels, the S.BUS O set
can be set between 0 to 9. For more details, see Table 8.1.
S.BUS O set
S.BUS Channel
WIRIS IO
0
1
1
0
7
7
1
1
-
1
2
1
1
7
6
9
10
1
9
16
7
Table 8.1 – S.BUS O set example - which S.BUS Channel corresponds to WIRIS IO
8.1.1 S.BUS through Amimon Connex
S.BUS signal from RC transceiver can be sent through Amimon Connex, so there is no need for the receiver. For
this, you need the Amimon Connex and RC transceiver with TRAINER support.
1. Connect the RC transceiver TRAINER port to Amimon Connex receiver.
2. Connect the Amimon Connex transceiver S.BUS port to WIRIS S.BUS input.
3. Set up the TRAINER channels in RC transceiver.
This se ng was tested with Futaba T148G RC controller (TRAINER se ng to 8 CH. mode).
Figure 8.5 – Amimon Connex TRAINER cable (le ) and S.BUS cable (right).
E-mail and Web
[email protected]
www.workswell.eu
Mobile:
+420 725 877 063
ID:
Reg. No.: 29048575
VAT No.: CZ29048575
Headquarters
U Albrechtova vrchu 12
155 00, Prague 13
Czech Republic
Revision 1.0.0 EN, 25
th
Oct, 2019
All pictures are only for illustra on.
Real values may vary.
22
