3
5.
Set lower limit: ensure step 1 has been complete before attempting step 5. (Generation 2 only)
a.
Use the UP and DOWN buttons to move the desk to the desired minimum height.
b.
Touch and hold the HOME button until a beep sounds and the display screen flashes.
c.
Touch the M2 button to complete the setting.
6.
Adjust the lower limit
a.
Touch the DOWN button to move the desk to its lower limit position.
b.
Touch and hold the HOME button until a beep sounds and the display screen flashes.
c.
Touch the DOWN button to cancel the previous lower limit.
d.
Repeat step 5 (Set lower limit) to reprogram lower limit.
Generation 3 (170823 and 180131)
1.
Adjust CMS (Collision Mitigation System) sensitivity for downward movement
a.
Touch and hold the HOME button until a beep sounds and the options menu appears.
b.
Use the UP and DOWN buttons to scroll through options A to F.
c.
Select A (when A is shown on the display screen) by touching the HOME button.
d.
Use the UP and DOWN buttons to scroll through the sensitivity levels 1 to 4.
e.
Select 1 (when 1 is shown on the display screen) by touching the M2 button.
f.
Touch the M2 button to return to normal function.
NOTE: It is always preferred to select sensitivity level 1. Never select level 4 as this turns off the
CMS.
2.
Adjust unit of measurement
a.
Touch and hold the HOME button until a beep sounds and the options menu appears.
b.
Use the UP and DOWN buttons to scroll through options A to F.
c.
Select B (when B is shown on the display screen) by touching the HOME button.
d.
Use the UP and DOWN buttons to scroll through the units for measurement options:
1 = CM
and
2 = INCH
.
e.
Select 1 (when 1 is shown on the display screen) by touching the M2 button.
f.
Touch the M2 button to return to normal function.
3.
Height Calibration
NOTE: complete this step before step 4.
a.
Touch and hold the DOWN button to move the desk to the lowest position (ensure all legs
are fully retracted).
b.
Touch and hold the HOME button until a beep sounds and the options menu appears.
c.
Use the UP and DOWN buttons to scroll through options A to F.
d.
Select C (when C is shown on the display screen) by touching the HOME button.
e.
Measure the physical height of the desk.
f.
Use the UP and DOWN buttons to match the displayed height to the measured height, to the
nearest centimetre.
g.
Touch the M2 button to complete the setting.
h.
Touch the M2 button to return to normal function.
4.
Set lower limit
NOTE: complete step 3 before step 4.
a.
Touch and hold the HOME button until a beep sounds and the options menu appears.
b.
Use the UP and DOWN buttons to scroll through options A to F.
c.
Select D (when D is shown on the display screen) by touching the HOME button.
d.
Use the UP and DOWN buttons to set the desired lower limit.
e.
Touch the M2 button to complete the setting.
f.
Touch the M2 button to return to normal function.
