Workspace Travel-X A6P Series, Инструкция пользователя

Страница: 8 / 8

7
U & D keys P OWN Display Screen Memory keys HOME key
The whole handset surface is a touch panel. If there is no touch within 30 seconds, the screen is locked and
M1/M2/HOME keys are locked correspondingly. You can touch Up or Down keys to unlock screen. When screen
lightened, all keys unlocked and handset enter operation state.
U & D keys P OWN
Touch and hold UP/DOWN key to adjust desk height until you get an optimum height.
Display Screen
Display the height value of the desk.
Memory keys
After setting memory keys, the desk can lift automatically to memory height.
Setting memory:
Touch and hold M1/M2 key for 5 seconds. When a “beep” sound is heard the memory height is
successfully saved. Then light touch M1/M2 to move the desk to memory height automatically.
HOME Key
light touch the HOME key. Desk moves to the optimal height of 72cm automatically.
Safety Function
If the desk encounters resistence while in motion, it will automatically stop and reverse its direction.
Error Codes and Solutions
Error Code
E1
E2
E3
E4
E5
HOT
Fault
Motor has stopped
Over 15mm height
difference between two legs
Loose wire or connection
Communication problem
Overloading problem
Overheating problem
Solution
Power off, wait and restart. If problem persists, then motor is damaged.
Lower desk to lowest position with both legs fully retracted. Power off, wait and
restart. If problem persists then further repair is required.
Power off, check cables and restart. If problem persists cable may be damaged.
Power off, check cables and restart. If problem persists further repair is required.
Lighten load to <180kg. Power off, wait and restart. If problem persists further
repair is required.
Allow motors to cool for 5 minutes before operating again.
Touch and hold HOME
key until the second beep
sound is heard (about 10 s).
Use
or keys UP DOWN
to choose , , , , or . A B C D E F
Adjust sensitivity for
downward movement
A
Touch
HOME key
1
2
3
4 Most sensitivity
General sensitivity
Least sensitivity
Anti-collision OFF
CM or INCH setting
B
Touch
HOME key
2
3 CM
INCH
Height calibration
C
Touch
HOME key
Use UP or DOWN key to match
displayed height to measured height
Set height lower limit
D
Touch
HOME key
Use UP or DOWN key to desired
lower limit position
Set height upper limit
E
Touch
HOME key
Use UP or DOWN key to desired
upper limit position
Adjust sensitivity for
upward movement
A
Touch
HOME key
1
2
3
4 Most sensitivity
General sensitivity
Least sensitivity
Anti-collision OFF
Touch M2 to complete
the setting
Touch M2 to return to
normal function