Worksman Eagle Lite, Руководство пользователя

Страница: 7 / 9

8. Install the handlebar stem
(#55A)
into the steerer tube, with the handlebar clamp facing forward. It must be
inserted beyond the minimum insertion line. Loosen the handlebar clamp nut. Insert and center the handlebar
into the clamp.
9. Rotate the handlebar within the clamp to the desired angle, then tighten the clamp. Pivot the handlebar about the
steerer fork until it is perpendicular to the front wheel, then tighten the stem bolt. Recommended torques are 300
in.lbs. and 240 in.lbs., respectively.
10. Attach brake hand lever (and shift lever for three-speed models) onto the handlebar. Cables should not be
tangled. Slide handlebar grips completely onto the handbar until tight. Do not use lubricants.
5) PEDAL ASSEMBLY
(See illustrations)
Pedals are marked on the shaft with either an
L
or
R
denoting left or right. The
R
pedal fits on the right (sprocket)
side of the crank arm. Tighten
clockwise
. The
L
pedal fits on the left side of the crank arm and is reverse-
threaded. Tighten
counter-clockwise
. Tightening in the wrong direction will strip the threads. Recommended
torque is 275 in.lbs.
6) SEAT ASSEMBLY
(See illustrations)
1. Insert seatpost
(#4908D)
completely into seat clamp
(#7913)
at bottom of seat. Tighten seat clamp bolt slightly.
2. Insert seatpost into frame. Tighten seat binder bolt. Recommended torque is 240 in. lbs.
3. Adjust seat angle; nose should point slightly upward. Tighten seat clamp bolt. Recommended torque is 240 in.
lbs.
4. Adjust seat height via the seat clamp nut at top of seattube. Do not raise above minimum insertion line.
7) REAR FENDERS
Attach fender braces to axle housing using provided nuts, U-bolts, and washers. Bend braces if they are rubbing the
tire.
8) REAR BASKET
1. Place basket on top of rear frame section.
2. Place retention strap in basket and align holes in strap with holes in frame.
3. Insert bolt and washer through the top. Install a nut and washer through the bottom. Tighten snugly but do not
overtighten.